Endura TRILENNIUM Guide

FACEPLATE REPLACEMENT INSTRUCTIONS
Parts Required
• Replacement Faceplate
• Replacement Screws
Tools Required
• T-15 Torx Screwdriver
• #2 Phillips Screwdriver
Remove Old Faceplate
Open door to expose faceplate.
Using the T-15 Torx screwdriver remove the Torx drive faceplate screws.
Using the #2 Phillips screwdriver remove the installation screws securing the lock to the panel.
Remove old faceplate.
A.
B.
C.
D.
Note
If lock is installed into a hung door panel, the installation screws should never be removed without a handleset or
construction handle installed, otherwise the lock may fall out of the panel.
!
Torx
Head
Screws
* 6/8 Lock shown- longer
locks will have more screws.
Torx
Head
Screws
INTERIOR EXTERIOR
Phillips
Head
Screws
Phillips
Head
Screws
AB, C, D

FACEPLATE REPLACEMENT INSTRUCTIONS
Install New Faceplate
Replace faceplate with new faceplate, and hold in place. Orient as
shown below.
Using a T-15 Torx Screwdriver, replace faceplate torx screws.
Using a #2 Phillips Screwdriver, replace the installation Phillips screws.
Note
Hand tighten all screws, do not over tighten. Do not use a power drill.
Orientation of Faceplate
Torx Screw Phillips Screw
The information contained in this document is the condential and proprietary information and trade secrets of Endura Products, Inc. Any disclosure,
use or dissemination of such information without the express written permission of Endura Products, Inc. is strictly prohibited. Endura Products, Inc.
also owns any and all intellectual property rights embodied in such information, including patent rights, copyrights, and trademark rights, and no
license of any intellectual property right is intended, nor should any license be implied, as a result of the receipt of this document.
Rev. 08.15.2017
8817 W. Market St., Colfax, NC 27235
1.800.334.2006 www.enduraproducts.com
A.
B.
C.
AB, C
!