Endura Trilennium 3070 Guide

1
Replacement Instructions
SKU: BD-INST-TRIL3070
Revised: 03.14.2017
8817 West Market Street, Colfax, NC 27235
800.334.2006 Fax: [phone]
www.enduraproducts.com
• Screwdriver or Drill
TOOLS REQUIRED:
• Trilennium®3070 Multipoint lock
• Mounting Screws
KIT INCLUDES:
* 6/8 Lock shown- longer
locks will have more
screws.
Phillips
Head
Screws
Phillips
Head
Screws
Note: You must rst remove the handle or grip lever before removing the lock.
Trilennium® 3070 Multi-Point
Locking System
STEP 1: REMOVE THE EXISTING LOCK, IF PRESENT, FROM THE ACTIVE DOOR PANEL
Loosen the screws that secure the
lock on the panel and remove the
existing lock. Clear out any debris
that may be in the exposed channel.
You do not need to remove the torx-
head screws.
Use caution while loosening the
screws, as without the securing
screws the lock may fall out.
!

2
Place the new lock face out into the channel.
Ensure the lock faceplate is ush with the
panel. Screw the lock in using the screws
provided.
NOTES:
• Check that the latch bevel faces the
strikes on the jamb and is the same as the
one that you are removing
• Conrm that the panic release
function is on the interior side of the lock.
• You do not need to remove the torx-
head screws.
STEP 2: INSTALL NEW LOCK