ENFORCER NE-SE01-020Q User manual




NE-SE01-020Q
Passive Ethernet Extender over Coax
Manual
1 Channel Ethernet over coax
10/100 Mbps Full duplex*
Transmission distance:**
-Up to 650ft (200m)@10Mbps
-Up to 325ft (100m)@100Mbps
Passive, no power required
Built-in surge protection
Fast and easy to install
Sold as a set

* Use only with 10/100 Switches
** Actual transmission range will vary depending on equipment used and cable grade.

ENFORCER Passive Ethernet Extender over Coax 
2SECO-LARM U.S.A., Inc.














Introduction:
ENFORCER Passive Ethernet Extender over Coax is designed to extend the range of any
TCP/IP device beyond the 300ft (100m) limit of Ethernet. The unit does not filter out any
protocols, codes, or applications, ensuring compatibility with any IP camera and its
software.
Specifications:
Type Passive Ethernet Extender over Coax
Range* 10Mbps (RG59) Up to 650ft (200m)
100Mbps (RG59) Up to 325ft (100m)
Input connector RJ-45
Output connector BNC
Link cable RG59/U or better
Ethernet speed 10/100 Mbps**
Standard IEEE802.3 10Base-T/100Base-T
Operating temperature -4°~158° F (-20°~70° C)
Dimensions 23/8"x11/8"x13/16" (60x29x20 mm)
(Excluding pigtail)

Parts List:
2x Passive Ethernet Extenders
1x Manual
Dimensions:
Note: Pigtail length is 5” (127mm)
Note: Both Ethernet extender units are the same size.
23/8” (60mm)
13/16” (20mm)
5/8” (16mm)
11/8” (29mm)
* Actual transmission range will vary depending on equipment used and cable grade.
** Use only with 10/100 Switches

ENFORCER Passive Ethernet Extender over Coax
SECO-LARM U.S.A., Inc. 3


Overview:
BNC Connector
RJ45
Installation:
1. Determine the location where the units will be placed as well as how much cable will be
required.
2. Connect one unit to an IP camera or other TCP/IP output device using Cat5e/6 cable of
not more than 6.5ft (2m).
3. Connect one unit to a DVR, PC or other TCP/IP receiving device using Cat5e/6 cable
Cat5e/6 cable of not more than 6.5ft (2m).
Connect via the Ethernet port found on the front of the Passive Ethernet Extender.
4. Run a coax cable between the two Passive Ethernet Extenders and connect both ends.
5. Switch on the IP source (i.e. CCTV camera) and verify that the system is functioning
properly.
Sample Application:
Passive Ethernet Extender1
NE-SE01-020Q
Coaxial cable
up to 650ft (200m)@10Mbps**
Cat5e/6 cable
(not more than 6.5ft)
IP Camera
NVR
Passive Ethernet Extender*
NE-SE01-020Q
*The passive Ethernet extender units are bidirectional transceivers. It can operate as a transmitter and receiver.
** Actual transmission range will vary depending on equipment used and cable grade.
Cat5e/6 cable
(not more than 6.5ft)

ENFORCER Passive Ethernet Extender over Coax 
4SECO-LARM U.S.A., Inc.

Troubleshooting:
IP Device does not function
correctly.
Make sure you are using the unit with 10/100 switches.
Make sure the Passive Ethernet Extender is connected
on both sides.
Make sure the IP source and DVR or PC are powered.
Test the coaxial cable between the units and make sure
it is functional.
Make sure that there are no problems with the IP
device, cables, or DVR by plugging the IP device
directly into the DVR or PC using the Cat5e/6 cables.
Make sure that the cables do not exceed the maximum
distance (see pages 2 and 3 for more details).
Also Available from SECO-LARM:
Passive VGA Balun
MVE-SV010Q
Passive 4-in-1 HD Video Baluns
EB-P101-01HQ
HDMI to VGA Converter
MVA-HV01Q
HDMI Extender over Coax
MVE-AA11-01NQ
CCTV Power Supplies
EVP-1SA4P9UL
Ethernet over Coax w/ PoE
NE-AE01-030TQ
NOTICE: The SECO-LARM policy is one of continual development and improvement. For that reason,
SECO-LARM reserves the right to change specifications without notice. SECO-LARM is also not responsible
for misprints. All trademarks are the property of SECO-LARM U.S.A., Inc. or their respective owners.
Copyright © 2017 SECO-LARM U.S.A., Inc. All rights reserved.
LIMITED WARRANTY: This SECO-LARM product is warranted against defects in material and
workmanship while used in normal service for one (1) year from the date of sale to the original customer.
SECO-LARM’s obligation is limited to the repair or replacement of any defective part if the unit is returned,
transportation prepaid, to SECO-LARM. This Warranty is void if damage is caused by or attributed to acts o
f
God, physical or electrical misuse or abuse, neglect, repair or alteration, improper or abnormal usage, or faulty
installation, or if for any other reason SECO-LARM determines that such equipment is not operating properly
as a result of causes other than defects in material and workmanship. The sole obligation of SECO-LARM and
the purchaser’s exclusive remedy, shall be limited to the replacement or repair only, at SECO-LARM’s option.
In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal o
r
property damage of any kind to the purchaser or anyone else.
SECO-LARM®U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606 Website: www.seco-larm.com PICFN1
Phone: [phone] | [phone] Email: [email protected] MI_NE-SE01-020Q_171207.docx