Entel CSAHX EE User manual

FEATURES
OPERATING INSTRUCTIONS
Thank you for purchasing the CSAHX rapid
charger. This product should reach you in perfect
condition. Should you notice any defects or
experience any problems with this product, please
contact the dealer from whom you purchased it
immediately.
The CSAHX charger provides rapid recharging
of Lithium-Ion battery packs for the Entel HX400
series transceivers.
Free-range power supply facilitates both 100v
and 240v AC outlets.
The HX400 series battery pack can be charged in
the front slot of the dual-slot CSAHX charger
while still attached to your HX400 transceiver, or,
alternatively, on its own in the rear slot. Two
battery packs may be inserted into the front and
rear slots simultaneously, but the battery pack in
the rear slot will only begin charging once the
battery pack in the front slot has completed its
charge cycle.
The time required to charge a fully discharged
battery pack is 2 hours, 30mins.
When rapid charge is complete, the CSAHX
automatically switches to standby.
This charger has been designed to sit on a
desktop.
1. Plug the AC power cord of the charger into a
wall outlet.
2. Switch the transceiver off.
3. Insert the battery pack into the CSAHX, either
with or without the transceiver attached.
The LED illuminates red to indicate that charging
has commenced.
4. A discharged battery pack will take
approximately 2 hours, 30mins to fully charge.
When charge is complete the LED will
illuminate green.
NOTE: If the LED on your CSAHX flashes red
this indicates that there is a fault with the battery
pack. Please consult your dealer.
CSAHX (EE/ED)
INTELLIGENT RAPID CHARGER
Copyright Entel UK 2009 v03/09

SPECIFICATION PRECAUTIONS
Mains connection: EE version - 3 pin UK
ED version - 2 pin European
Input voltage: 100~240V AC 500mA
Ouput voltage: 8.4V DC 800mA
Charge time: 2 hours, 30mins
Dimensions: 61(H)mm x 100(W)mm x 147(D)mm
Weight: 369g
Community Design Registration Pending
U.S Design Patent Pending
Unregistered Design Right Entel UK 2008
All Rights Reserved
Copyright Entel UK Ltd. London
The CSAHX is designed exclusively for use with
battery packs related to the Entel HX series.
Do not use it to charge any other types of battery
pack.
Do not use the CSAHX as a power supply.
The CSAHX is designed for use with an AC power
supply voltage between 100v and 240v. Do not
connect it to a power source outside this range.
Never charge the transceiver whilst it is switched on.
Unplug the CSAHX when it is not in use.
Do not dismantle the CSAHX.
Never insert any metal or any other conductive
objects into the charger.
Do not touch the charger's terminals.
Never short the charge contacts with metal or any
other conductive object.
The CSAHX should be placed in a well ventilated,
dry area.
!In the event that your CSAHX gets wet, do not
switch on. Consult your dealer immediately.