ESI LIFT-WB-SLV User manual

ASSEMBLY AND ADJUSTMENT
LIFT-WB Model LIFT-WB-SLV
FREE-STANDING BASE
LIFT-WB Rev A 3/17

2
PLEASE REVIEW these instructions before beginning the assembly and adjustment procedures. Check that
all the parts and tools listed below were provided with your order. Contact your supplier if any materials are
your satisfaction.
LIFT-WB PARTS AND TOOLS
Main Assembly (1) Keyboard Platform (1)
M6x8mm Screw (2) Keyboard Hole Plug (2)
4mm Allen Key (1) 6mm Allen Key (1)
PARTS AND TOOLS PROVIDED
CAUTION:
Hand-tighten screws only. Do not use power tools.
WARNING: When you first squeeze the paddle lever to operate this product, there is
no load on the unit (weight of monitor, keyboard, etc.). Firmly hold the top platform
to control the rate of movement. Take appropriate precautions to avoid pinching or
otherwise injuring yourself.

3
Attach Paddle
Holes for the activating paddle are pre-drilled into the top platform on both the left and right sides. You
may attach the paddle on either side, depending on user preference.
• Use the 4mm Allen key to fasten the paddle to the top platform.
Position the Main Assembly on the Work Surface
• The work surface must be a minimum of
24" in depth.
WARNING: Do not allow the base
to hang over the edge of the work
surface!
ASSEMBLY LIFT-WB
24"
Minimum
Paddle
Top Platform

4
Attach Keyboard Platform
• Using the 4mm Allen key, attach the keypad with the M6x8 screws, as shown. Tighten securely.
Change Side of Keyboard Wristpad, If Desired
By default, the keyboard wristpad is on the left side for a right-side mouse. If desired, it may be changed to
the right side for a left-side mouse.
• Using the 4mm Allen key, remove the screws holding the wristpad from the underside of the keyboard
platform. Remove the plug from the far right-side hole.
• Re-install the screws to attach the wristpad to the right side of the keyboard platform. Use one of the new
plugs provided to conceal the exposed left-side hole.
LIFT-WB ASSEMBLY
Keyboard Platform
M6x8 Screws
Right-Side Mouse Left-Side Mouse

5
ADJUSTMENT LIFT-WB
Test Operation
• Place the monitor and other equipment that will be used with this
product on the top platform and keyboard platform.
• Depress the paddle lever. Raise and lower the unit through its full range of
movement.
• Position the unit so the support beam is at a 45° angle. If necessary, make
product.
45°
If Necessary, Adjust for Load Weight
This adjustment can be used to maximize ease of operation. When operating this product, the platform
should move easily to any position and hold that position.
•
• – ).
• Use the 6mm Allen key to turn the adjusting screw — counterclockwise to increase load, clockwise to
decrease it.
• Test operation and re-adjust as necessary.
CAUTION: Do not overtighten the MAX (+) adjustment.
6mm Allen Key

800.833.3746 esiergo.com
© 2017 ESI Ergonomic Solutions. All rights reserved. LIFT WB Rev A 3/17