Etac Molift Mover 180 User manual

Molift Mover 180, Quick guide | QG08101 Rev. B | www.etac.com
Quick guide (EN)
QG08101 Rev B 2022.10.17
Molift Mover 180
Important
Read user manual before use! This Quick guide does not replace user manual. It is important to fully understand the
content of the user manual before attempting to use the equipment.
Go to www.etac.com for latest version of the user manual.
Never exceed the Safe Working Load (SWL) of 180 kg (397 lbs).
If maximum load (SWL) differs between hoist and body support unit, then the lowest maximum load shall always be
used.
Molift hoists shall only be used to lift persons. Never use the hoist to lift or move objects of any kind.
Lifting arm
Push
handles
Motor / actuator
Emergency
stop
Hexagon
socket screw
Legs
Electric emergency
lowering
Chassis
Sling bar
Battery
Lifting column
Manual emergency lowering
Hand
control
Wheel / castor (Rear with brake)
Hexagon
socket screw
Service
indicator Mode
No light Power saving
(Stand by)
Green Ready for use
Yellow Order service
Red Perform service
Red + sound Perform service
immediately
Battery
indicator Mode
Light Low battery
No light Charged battery

Etac A/S
Parallelvej 3
DK-8751 Gedved
www.etac.com
Molift Mover 180, Quick guide | QG08101 Rev. B | www.etac.com
Handcontrol and opreation
Sling bar placement and sling attachment
User positions for transfer and lowering
①
② ③ ④
Never lift the user higher than
necessary to carry out a lift.
Remember that wheels on a mobile
hoist must NOT be locked.
The hoist shall not be used to lift or
move users on sloping surfaces.
Do not push or pull the user, lifting arm or
actuator.
This may cause stability problems and
hoist may tip over.
Never leave a user unattended in a lifting
situation.