ETEKCITY EK8060 User manual

1
Digital
Kitchen Scale
Model: EK8060
User Manual
Questions or Concerns?
Mon–Fri, 9:00 am–5:00 pm PST/PDT
[e-mail] • [phone]

2
If you have any questions or concerns, please reach out to our
helpful Customer Support Team at [e-mail]. We
hope you enjoy your new kitchen scale!
Get exclusive deals, giveaways, and product registration.
Better products for better living.
Find us at etekcity.com
Thank you for purchasing the
Digital Kitchen Scale by Etekcity.
Become an Etekcitizen

3
Table of Contents
Package Contents
Specifications
Important Safety Information
Function Diagram
Symbols
Using Your Scale
• General Operation
• Zero / Tare Function
• Unit Conversion
• Automatic Power Off
• Manual Power Off
Replacing the Batteries
Troubleshooting
Warranty Information
Customer Support
3
3
4
5
6
6
6
7
8
8
8
8
9
10
12
Specifications
Package Contents
Weight Capacity 176 oz / 11 lb / 5000 g / 5000 mL
Units oz / lb:oz / fl oz (water/milk) / g / mL (water/milk)
Increments 0.04 oz / 1 g / 1 mL
Auto-Off 180 seconds
Battery 2 x 3V CR 2032 batteries
Dimensions 8.3 x 6.3 x 0.6 in / 21 x 16 x 1.6 cm
1 x Digital Kitchen Scale
2 x 3V CR 2032 Batteries (Pre-Installed)
1 x Quick Start Guide

4
• Always place the scale on a hard, dry, and flat surface before
measurement in order to ensure accuracy.
• Do not exceed the 11 lb / 5000 g weight capacity as it will damage
the scale. An error indicator will appear on the LCD display if the
limit is exceeded.
• Do not immerse the scale in water or any liquid. If liquid is spilled on
the digital display or buttons, immediately wipe the scale dry with a
soft cloth to avoid internal damage.
• Handle with care. This scale is not intended for commercial or
heavy-duty use.
• Keep the scale in a cool, dry place. Avoid exposure to damp
environments or extreme temperatures.
• Household use only.
• Do not mix new and old batteries.
• If the low battery indicator “ “ appears on the display, replace the
batteries.
• If the scale is not in use for an extended period of time, remove the
batteries to conserve battery life and extend the lifetime of the scale.
Important Safety Information
SAVE THESE INSTRUCTIONS
To avoid damage to this scale, please read and follow all instructions
and safety guidelines in this manual.
Scale
Batteries

5
Function Diagram
A. Unit Selection Button
B. LCD Display
C. Power/Tare Button
D. Battery Compartment
E. Screw
F. Anti-Skid Pads
A
BC
D
F
E

6
Using Your Scale
Note:
• For accurate results, always place the scale on a hard, dry, flat
surface, and keep the scale away from dirt, dust, vibrations, wind, air
currents, and electromagnetic interference.
• When you turn on the scale, choose units, or use the tare function,
wait for the display to read before measuring.
• The batteries are pre-installed in the scale. Turn the scale over and
pull the plastic strip out from the battery compartment.
General Operation
1. Place the scale on a hard, flat, level surface.
2. Press TARE to turn on the scale. Make sure the display reads .
Press UNIT to select your desired measuring unit, which will show on
the right of the display.
3. Place your item on the scale.
4. Wait for the reading on the display to stabilize.
Symbols
Solids Water (Liquid) Milk

7
Zero / Tare Function
1. Press TARE to turn on the scale. Make sure the display reads . If
the screen does not display automatically, press TARE to
auto-adjust to zero.
2. Place the container on the center of the scale.
3. Wait for the reading on the display to stabilize. The display will show the
container’s weight.
4. Press TARE to tare the weight of the container. The screen should now
display .
5. Place the liquid or items into the container. The scale will measure the
contents without including the weight of the container. [Figure 2.1]
6. When you’re done, reset the scale by removing all weight and pressing
TARE again.
Whenever you measure items inside a container, you can use the tare
function to remove the container’s weight from the final measurement.
Figure 2.1

8
Unit Conversion
Automatic Power Off
Manual Power Off
To change the unit of measurement, press UNIT until the display shows the
desired unit of measurement.
To save battery power, the scale will automatically power off after 180
seconds of inactivity.
Press and hold TARE for 2 seconds to turn off the scale.
Replacing the Batteries
1. Turn the scale over and open the battery compartment.
2. Take out the used batteries and replace them with 2 new 3V CR 2032
batteries.
3. Replace the battery compartment cover and screw it shut.

9
Troubleshooting
Problem Possible Solution
Scale does not turn on.
Open the battery compartment cover and remove the
plastic strip.
Replace the batteries (see page 8).
Make sure batteries are inserted under the correct
polarity as marked in the battery compartment.
Reading is inaccurate.
Place scale on a level surface.
Make sure the screen displays before
measuring (see Zero / Tare Function, page 7).
Remove the batteries for 45 seconds, then replace
them to reset the scale.
Display shows
Item is too heavy. Remove item from scale to protect
its weight sensors. Use a different scale with a higher
weight range.
Display shows Calibration error. Turn the scale off and on again.
Avoid moving the scale while measuring.
Display shows Battery power is low. Replace the batteries
(see page 8).
If your problem is not listed, please contact Customer Support (see page 12).

10
Warranty Information
Terms & Policy
Etekcity Corporation warrants all products to be of the highest quality in
material, craftsmanship, and service, effective from the date of purchase
to the end of the warranty period.
Etekcity Corporation will replace any product found to be defective due
to manufacturer flaws based on eligibility. Refunds are available within
the first 30 days of purchase. Refunds are only available to the original
purchaser of the product. This warranty extends only to personal use
and does not extend to any product that has been used for commercial,
rental, or any other use in which the product is not intended for. There
are no warranties other than the warranties expressly set forth with each
product.
This warranty is non-transferrable. Etekcity Corporation is not responsible
in any way for any damages, losses, or inconveniences caused by
equipment failure or by user negligence, abuse, or use noncompliant with
the user manual or any additional safety or use warnings included in the
product packaging and manual.
Product Digital Kitchen Scale
Model EK8060
Default Warranty Period 1 year
For your own reference, we strongly recommend that you record your
order ID and date of purchase.