EtherWAN ED3238 User manual

ED3238 www.etherwan.com
70G-ED3238XQ1
1
This quick start guide describes how to install and use the Ethernet Extender over coaxial cable. This is the Ethernet
Extender of choice for environments constrained by space.
Installation
ED3238T (Transmitter): This is a PoL (Power over Link) transmitter. Data and power can be delivered at the same
time through a coaxial cable to turn on and communicate with ED3238R (Receiver) via BNC interface.
ED3238R (Receiver): This is a PoL (Power over Link) Receiver. ED3238R (Receiver) can be powered by ED3238T
(Transmitter) through a coaxial cable. The Ethernet port of ED3238R (Receiver) supports IEEE802.3af PoE/PSE for
fulfilling PoE/PD application.
Physical Description
The Port Status LEDs and Power Inputs
ED3238T
ED3238R
LEDs State Indication
Steady Power received
POWER Off Power off
Steady A valid Extender connection established
Flashing Data transmission or receiving
LINK/ACT Off Extender connection is not established
Steady Powered device (PD) is connected
PoE Off Powered device (PD) is disconnected
Steady A valid Ethernet connection established
Flashing Data transmission or receiving
Green Off No valid Ethernet connection established
Steady Link speed at 100Mbps
Yellow Off Link speed at 10Mbps

ED3238 www.etherwan.com
70G-ED3238XQ1
2
10/100Base-TX Connectors
10/100Base-TX Connection
The following lists the pinouts of
10/100Base-TX RJ-45 port.
Pin Regular Port PoE Port
1 Output Transmit Data + Output Transmit Data +
2 Output Transmit Data - Output Transmit Data -
3 Input Receive Data + Input Receive Data +
4 Positive (VCC+)
5 Positive (VCC+)
6 Input Receive Data - Input Receive Data -
7 Negative (VCC-)
8 Negative (VCC-)
Functional Description
Ethernet port: Supports IEEE802.3/802.3u/802.3x. Auto-negotiation: 10/100Mbps, full/half-duplex. Auto
MDI/MDIX.
BNC interface: 100Mbps full-duplex throughput for Power over Link (PoL) application runs up to 250 meters
on RG11 and 180 meters on RG6 coaxial cables.
Operating temperature range @ -10℃to 50℃(14℉to 122℉).
ED3238T:
Can be PoE/PD powered by IEEE802.3at PoE/PSE device through Ethernet port of ED3238T or can
be powered by 57VDC power adapter through DC Jack interface of ED3238T.
Input Power Rating (optional): DC Jack: 57VDC, 0.52A minimum; PoE connector: 50-57VDC, 0.52A
minimum.
ED3238R PSE port: 15.4 Watts.