EtherWAN ED3501 User manual

Copyright 2018 EtherWAN Systems, Inc. Page 1
All Rights Reserved
ED3501 rev. 2.0
8/16/2018
W70G-ED3501XQ3
1 Unpacking
Unpack the items. Your package should include:
One ED3501 Industrial Ethernet Extender
One CD containing this user’s guide
If items are missing or damaged, notify your
EtherWAN representative. Keep the carton and
packing material.
2 Select a Location
Installations: Desktop, Wall-mount, DIN-Rail
mount.
Identify a power source within 6 feet (1.8
meters).
Choose a dry area with ambient temperature
between -10 and 60ºC (14 and 140ºF).
Keep away from heat sources, sunlight, warm
air exhausts, hot-air vents, and heaters.
Be sure there is adequate airflow.
Keep the device at least 6 ft (1.83 m) away
from the nearest source of electromagnetic
noise, such as a photocopy machine.
3 Connect to the Data Ports
LED
Color
Status
PWR
Green
ON = Receiving power.
OFF = Power off.
Ethernet Extender Port
Link/Activity
Green
ON = Connection is established.
OFF = No connection is established.
Flashing = Port is sending or receiving
data.
Per
Green
ON = Performance mode.
OFF = Standard mode.
RMT
Green
ON = Remote mode.
LOC
Green
ON = Local mode.
SYM
Green
ON = Symmetric mode.
ASM
Green
ON = Asymmetric mode.
Line Speed
Green
ON = Displays the link speed in Mbps.
10/100TX Port
Link/Activity
Green
ON = Valid network connection.
OFF = No data transmission on port.
Flashing = Port is sending or receiving
data.
Speed
Yellow
ON = Link speed at 100Mbps.
OFF = Link speed at 10Mbps.
A. Insert one end of the Ethernet cable into a
switch port.
B. Connect the other end into the Ethernet port
of the device.
C. Insert the voice grade copper wire between
one pair of Ethernet Extenders via Ethernet
Extender port (RJ-11 connector or Terminal
Block). One device must be set to LOC mode
and the other to Auto mode when two
devices are connected.
4 Apply DC Power
Connect the supplied AC to DC power adaptor to
the receptacle on the rear panel of the Ethernet
Extender, and then attach the plug into a
standard AC outlet.
ED3501 Industrial Ethernet Extender Installation Guide

ED3501 Industrial Ethernet Extender Installation Guide
Copyright 2018 EtherWAN Systems, Inc. Page 2
All Rights Reserved
ED3501rev. 2.0
8/16/2018
W70G-ED3501XQ3
5 DIP Switch
Pin
Up
Down
DIP Switch 1
Auto mode
Local mode
DIP Switch 2
Symmetric
Asymmetric
DIP Switch 3
Performance
Standard
NOTE: After making changes to the position of
any DIP switch, the Ethernet Extender must be
rebooted for the new settings to take effect.
6 Top Panel
Distance and data rate for Ethernet
Extender port:
Distance (m)
Data Rate (Mbps)
300
100
400
80
600
60
800
40
2600
1
This distance/data rate information is measured
according testing standard in EtherWAN
laboratory. The actual installation will be
affected by the quality of copper wire and the
impact of noise disturbance. The connection
speed will be affected.
Ethernet Extender Connection
The RJ-11 and Terminal Block port pinouts
Pin 3: Tip, Pin 4: Ring.
Use a telephone line to connect two RJ-11 or
Terminal Block ports between two Hardened
Ethernet Extenders.