Ethnicraft REVIVE BED User manual

SYMBOLS
SMBN
SELY INSTRUCTIO
NOTICE
DIRECTION NUMBER OF
PERSONS NEEDED
USE SCREWDRIVER
TO TIGHTEN
A
HARDWARE ENCLOSED
IN YOUR PACKAGE :
ASSEMBLY INSTRUCTIONS
HARDWARE (AS LISTED ABOVE)
PARTS TO BE INSTALLED
1. HEADBOARD (1 pc)
2. SIDERAIL (2 pcs)
3. FOOTBOARD (1 pc)
4. MIDDLE SUPPORT (1 pc)
REVIVE BED - WITHOUT SLATS
ASSEMBLY INSTRUCTIONS FOR BED INSTALLATION
USE HAND
1 / 4
SCREW
M6x25
(32pcs)
X2
TOOL REQUIRED
SCREWDRIVER
(Not include in package)
METAL BRACKET
(4pcs)
L BRACKET
(4pcs)
1
2
2
3
4
( L )( L )( L )
( R )( R )( R )

2 / 4
INSTALLING METAL BRACKET TO SIDERAIL
A
ATTACHING SIDERAIL TO FOOTBOARDB
1
2
- USE METALBRACKET (4X)
- USE SCREW M6x25 (16X)
- TIGHTEN FULLY
2
1
2
- USE SCREW M6x25 (8X)
- TIGHTEN FULLY
2( R )( R )( R )
2( L )( L )( L )
3
REVIVE BED - WITHOUT SLATS
ASSEMBLY INSTRUCTIONS FOR BED INSTALLATION

3 / 4
ATTACHING SIDERAIL TO HEADBOARD
C
ATTACHING MIDDLE SUPPORT D
1
1
2
- USE SCREW M6x25 (8X)
- TIGHTEN FULLY
4
1
2
NOTE :
THIS IS A COMPULSORY ACTION TO MAKE SURE
CENTER LEG TOUCH THE GROUND!
REVIVE BED - WITHOUT SLATS
ASSEMBLY INSTRUCTIONS FOR BED INSTALLATION

4 / 4
ATTACHING L BRACKET
E
FINISHF
1
2
x
x
INSTALLING SLAT SUPPORTS AT THE SAME LEVEL
REVIVE BED - WITHOUT SLATS
ASSEMBLY INSTRUCTIONS FOR BED INSTALLATION

REMOVABLE COVER OF REVIVE BED
ASSEMBLY INSTRUCTIONS FOR COVER INSTALLATION
INSTALLING COVER
UNINSTALL COVER
1
2
- USE ANGLE BRACKET (4X)
- USE SCREW M6x25 (16X)
- TIGHTEN FULLY