EVBOLT ASTEROPE 3 User manual

Intellectual property of EVBOLT, Inc
Electric Vehicle DC Charger
ASTEROPE 3 Pedestal – Installation Manual

Intellectual property of EVBOLT, Inc
Page 1 of 7
1.Pedestal Dimensions
2.Unpack
60cm(23.62 in)
15.2cm(5.98 in)
60cm (23.62 in)
145cm(87.08 in)
30cm(11.84 in)

Intellectual property of EVBOLT, Inc
Page 2 of 7
3.Packing List
No. Description Qty Notes
1 Main body 1
2 Bottom plate
3 M12 expansion screw L100mm 6
4 Screw round M8x20 6
5 M4x10 countersunk screw 25
6 M4x10 round screw 6
7 M6 nut 2
8 M6x16 round screw 9
9 Installation guide 1
4.Installation
STEP 1
Prepare a concrete base
The concrete pad building should be compliance with regulatory and local code requirements. The following
descriptions of the dimension or structure are minimum recommendation.
20cm(7.87in)
70cm(27.56in)
70cm(27.56in)

Intellectual property of EVBOLT, Inc
Page 3 of 7
STEP 2
Mount 6 pieces of M12 Expansion screw on the concrete pad according to the below dimensions. (The depth of
Expansion screw hole is at least 11 cm.). Implantation ± 23cm conduit for input DC and Ethernet cables.
STEP 3
Screw 6 sets of expansion screws to the bottom of the stand as illustrated.
70
18.5
36.3 38.8
56.5
20 23
70
14.51527.513
Ø10
Ø4.5

Intellectual property of EVBOLT, Inc
Page 4 of 7
STEP 4
Mount 6 screws as illustrated below.
STEP 5
Place the bottom plate as indicated below and then screw the four M12 expansion screws.

Intellectual property of EVBOLT, Inc
Page 5 of 7
STEP 6
Screw 2 sets M4x10 screws and nut to the bottom of the stand.
STEP 7
Position the bracket comes with ASTEROPE 3 wall mount charger as illustrated below, fasten with 4pcs M8xL12
screws marked in red.

Intellectual property of EVBOLT, Inc
Page 6 of 7
STEP 8
According to the figure below, mount two M6 screws marked in red.
STEP 9
Assemble the arms of the connector holder on both sides, fasten with 4 pcs of M8 screws for each arm.

Intellectual property of EVBOLT, Inc
Page 7 of 7
STEP 10
Put on the connector base on both sides and fasten with 2pcs of M8 screws for each.
STEP 11
Assemble the connector holders on both sides and fasten with 4pcs of M5 screws for each.

Intellectual property of EVBOLT, Inc
© 2022 EVBOLT INC. All Rights Reserved.