exhart 71387-RS User manual

Step 1:
Attach stake base (B) to top pole (A) by screwing
it to the right until it is firmly tightened.
When everything is assembled, insert stake base firmly into the ground. For best results, install on flat ground and
ensure that the stake is 90 degrees vertical to the ground.
Step 2:
Add pellet seeds (longer than 5mm) into opening
located in the back.
Top Pole Stake Base
Note:
Product (Top Pole) will vary depending on the item purchased.


71387-RS

OFFON
Ni-MH
Battery must be recycled or
disposed of properly. Do not
short circuit or dispose of in re.
FOR DECORATIVE USE IN THE GARDEN. NOT TO BE GIVEN TO CHILDREN AS TOY.
© 2020 Exhart - Chatsworth, CA 91311. Made in China / Fabrique en Chine. All Rights Reserved.
For help please call 1-800-775-5503 | [email protected]
exhart.com
OPERATION
ON/OFF: The unit is shipped in the OFF position. Locate the ON/OFF button on the bottom of
the unit and slide it into the ON position (Photo #1). In the ON position, the solar cell will light
up automatically at dusk and will shut OFF automatically when the solar panel is exposed to
daylight.
Location: Select a sunny location. Place the unit in direct sunlight for at least one day to fully
charge the battery. The more direct sunlight your new solar light is exposed to during the day,
the longer the light will operate in the evening.
MAINTENANCE
Cleaning: The solar panel has an epoxy cover that will need to be kept free of dirt and debris,
and snow, all the time. Wipe the panel periodically with a damp cloth. Failure to do so will
prevent the battery from charging properly, reducing operating time and the life of the battery.
Check the battery periodically, especially after winter months, and replace when necessary.
The battery may need to be replaced after a year of continuous use. To replace, open the
battery compartment by unscrewing the three screws (Photo #2) and pulling the battery cover
off the unit (Photo #3). Replace the battery with a 300mAh Ni-MH AA 1.2V rechargeable
battery (Photo #4). The capacity of the replacement battery shall not be less than the
recommended capacity. Replace the battery cover and screw three screws in firmly to seal
the unit.
Warning:
• Only use rechargeable Ni-MH AA 1.2V battery.
• Failure to insert the battery in the correct polarity, as indicated in the battery compartment,
may shorten the life of the battery or cause the battery to leak.
• Do not dispose of batteries in fire, or heat, as battery may explode.
• Do not open, short circuit, or mutilate battery, as injury may occur.
• Batteries should be recycled, or disposed of, in accordance with Federal, state and local
regulations.
• Electrical rating is 0.05W.
Photo 2
Photo 1
Photo 3
Photo 4