Extreme marquees EMX ALPHA User manual

We Design |We Manufacture |We Sell |We Deliver Australia Wide
www.extrememarquees.com.au [email protected] 1300 850 832
EMX ALPHA INSTRUCTIONS
LAY OUT ACCESSORIES INFLATION SECURING ENJOY
Inflation & Deflation
Lay the inatable frame at on the
ground with zips facing upwards.
Zip roof to frame. (Roof installation will
only need to be done on rst use)
Unroll roof and lay on top of the frame.
lining up the roof and frame zippers.
1. 2. 3.
Roof Installation
Initial attachment required on first use only.

Remove Inatable Tent from
Protective Cover.
Lay the Inatable Tent out at & extend
all legs.
Roll out the Inatable Tent.
Each leg on the Inatable Tent has a valve.
Ensure all valves are closed. Open one valve
and connect pump to inate.
Layout walls and awning. Conrm
positioning and zip together.
During the ination process, when legs
become rm push up from underneath.
Ensure all legs are lined up and canopy
is centered. Check frame is rm.
Connect the pump to selected Ination
Valve and begin ination.
IMPORTANT NOTES:
• Check the wind and weather conditions before
commencing construction.
• Ensure you have the correct ground xings for
your application.
• For safety reasons it is recommended that 2
persons set up any Inatable Tent.
• Ensure area is free from any sharp objects &
overhead objects.
• In high winds or storms the inatable should
be deated and stowed away.
• Green guide ropes should be used in
moderate to strong wind conditions.
• Do not touch the over
pressure valve system
Position awning support tube into the
Velcro located at the leg hub. Insert
the two berglass rods into position to
tention awning.
We Design |We Manufacture |We Sell |We Deliver Australia Wide
www.extrememarquees.com.au [email protected] 1300 850 832
EMX ALPHA INSTRUCTIONS
Inflation Instructions
WARNING READ INSTRUCTIONS CAREFULLY BEFORE USE
1.
4.
7.
10.
2.
5.
8.
3.
6.
9.
Connect pump to awning valve and
inate until awning is rm. (Do not over
inate)
11 .
Fix two water weights per frame leg.
Attach leg strap to bottom water
weight. Green guide ropes should
be used in moderate to strong wind
conditions.

ACCESSORIES
Stakes Repair KitSandbags Pump
Hammer / MalletGenerator Extension Lead
INCLUDED ITEMS:
NOT INCLUDED
Fold Tent up neatly laying the Canopy
and Legs on top of each other.
Roll Tent up.
Pack the dry and clean Inatable Tent
into Protective Cover.
Ensure area is clear of persons.
Ensure area is dry and clean.
Unscrew all valves to deate Tent.
Remove Stakes and Guide Ropes or
detach Sandbags.
Remove all air from the tubes.
We Design |We Manufacture |We Sell |We Deliver Australia Wide
www.extrememarquees.com.au [email protected] 1300 850 832
EMX ALPHA INSTRUCTIONS
Deflation Instructions
WARNING READ INSTRUCTIONS CAREFULLY BEFORE USE
1.
4.
2.
5.
3.
IMPORTANT NOTES:
• Check the wind and weather conditions before
commencing construction.
• Ensure you have the correct ground xings for
your application.
• For safety reasons it is recommended that 2
persons set up any Inatable Tent.
• Ensure area is free from any sharp objects &
overhead objects.
• In high winds or storms the inatable should
be deated and stowed away.
• Green guide ropes should be used in
moderate to strong wind conditions.
• Do not touch the over
pressure valve system