
EMX Alpha / Beta / Delta / Gamma / Omega Ranges
WARNING READ INSTRUCTIONS CAREFULLY BEFORE USE
INFLATABLE INSTRUCTIONS
Recommended procedure below. For safety reasons it is recommended that 2 persons set up any marquee.
Ensure area is free from any sharp objects & overhead objects.
SETUP - INFLATION
Remove Inatable Marquee from
Protective Cover.
Lay the Inatable Marquee out at.Roll out the marquee.
ONE TWO THREE
During the ination process raise legs
into the center until all legs are upright.
Ensure all legs are lined up and roof
is centered. Check frame is rm.
Connect the pump to selected Ination
Valve and begin ination.
SEVEN EIGHT NINE
Each leg on the marquee has a valve. Select
valve to attach pump, screw inatation value
closed and leave cap o.
On all other valves screw tight and x cap.
Marquee Accessories*
Layout your Walls and Awnings and
conrm positioning.
Attach the accessories using zips.
SIXFOUR FIVE
Fix Steel Pins and Guide Ropes or
attach Sandbags.
Over pressure relief valve system,
DO NOT TOUCH.
IMPORTANT NOTES:
Check the wind and weather
conditions before commencing
construction.
Ensure you have the correct ground
xings for your application.
When the marquee is in use, do not
leave your marquee unattended.
TEN
W
e
design
|We manufacture |We sell |We Deliver Australia wide www.extrememarquees.com.au [email protected] 1300 850 832