Eyedro E5B-M-GWE3 User manual

Quick Start Guide
3-Phase
Electricity Monitoring System
(includes Gateway)
with Wireless Mesh connectivity
Model: E5B-M-GWE3 /
E5B-M-GWE3-SUB
For applications not exceeding
600VAC
Visit eyedro.com for any
questions or comments.
We value your feedback.
Online Support Resources
Visit eyedro.com/support for online product setup
wizard, user manuals, videos, and various support
resources
Limited One Year Warranty
Full warranty details are available in the Product
Guide at eyedro.com/support.
Important: This product contains no user serviceable
components. Do not attempt to open the case of the
unit or tamper with the internal components. Doing so
will void the product warranty.
eyedro.com/support
Before Getting Started
This Quick Start Guide provides very high level
installation instructions. Detailed installation in-
structions are available in the Product Guide at
eyedro.com/support
This product is intended for indoor use only
Installation may require the cover of the main electrical panel to
be removed while some wires are still electrified. Even when the
main breaker has been turned ‘OFF’ certain areas of the panel
may still be dangerous and carry the risk of shock, burn, and elec-
trocution. Installation should be performed by a qualified electri-
cian. DO NOT attempt installation unless you know where
electrified areas within the panel are.
Notes:
1. Always use the AC power adapter that came with your
E5B-M-GWE3(-SUB) system.
2. Do not plug your Eyedro power adapter into an Uninterruptible
Power Supply (UPS) as this will result in incorrect measure-
ments.
3. The AC power adapter must be powered via a circuit
that is downstream of the panel where the current sensors are
installed.

Always use the correct
power adapter!
Use the 5VDC power adapter with the
Gateway module:
Use the 6VAC power adapter with the
Sensor module:
Support manuals and videos:
Eyedro.com/support
Qty. Description
A1Eyedro gateway module
B1Eyedro sensor module (3 port)
C15VDC power adapter (for gateway)
D16VAC power adapter (for sensor)
E3200A current sensor (Sensors NOT in-
cluded with –SUB system)
F11m (3ft) Ethernet cable
3.2 Connect one end of the supplied Ethernet cable to
an open port on your router.
2. Record Serial Number:
(located under barcode on module)
_ _ _ - _ _ _ _ _
Gateway SN:
_ _ _ - _ _ _ _ _
Sensor SN:
3.3 Connect current
sensors and 6VAC
power adapter to the
sensor module.
3.4 Connect Ethernet
cable and 5VDC
power adapter to the
gateway module.
1. Verify Package Contents 3. Install Hardware
3.1 Install current sensors on the line1 conductor of
the circuit(s) to be monitored.
1Line/Live/Hot conductor(s)
Copyright © 2023, Eyedro Green Solutions Inc.
4. Create a MyEyedro User Account
4.1 Go to my.eyedro.com to create your online
account (or log in if you have an existing account).
4.2 Add the device to your user account:
go to Configuration, select Devices then enter the
serial number you recorded in Step 2.
4.3 ENJOY! Log into MyEyedro as often as you like to
view your electricity consumption.
4.4 For more details about the MyEyedro cloud service,
review the MyEyedro User Guide located at
eyedro.com/support