Eyedro E5B-M-P2 User manual

Quick Start Guide
Pulse Monitoring System
with Wireless Mesh connectivity
Model: E5B-M-P2
Before Getting Started
This Quick Start Guide provides very
high level installation instructions. De-
tailed installation instructions are availa-
ble in the Product Guide at
eyedro.com/support
This product is intended for indoor use only
Eyedro Pulse Monitors are intended to interface with
the following pulse meter output formats:
Form A (KY) dry contact pulses
5V DC wetting value
Rising or falling edge detection (default is rising edge)
Minimum pulse width is 5ms
Maximum frequency is 100Hz
NOTE: A higher wetting value (up to 24V) can be
achieved by connecting a separate DC power supply
(not provided) to input port C of the Eyedro Pulse
Monitor module. The mating connector for port C is a
1.65mm (i.d) x 3.5mm (o.d) x 9mm (length) barrel
plug with center pin positive.
Online Support Resources
Visit eyedro.com/support for online product setup
wizard, user manuals, videos, and various support
resources
Limited One Year Warranty
Full warranty details are available in the Product
Guide at eyedro.com/support.
Important: This product contains no user serviceable
components. Do not attempt to open the case of the
unit or tamper with the internal components. Doing so
will void the product warranty.
eyedro.com/support
Visit eyedro.com for any
questions or comments.
We value your feedback.

Quantity Description
A1Eyedro pulse module
B2Pulse interface cables
C15VDC power adapter
3.1 Connect pulse interface cable to the output of the
pulse meter.
• Black wire of the pulse cable to the K output
• White wire of the pulse cable to the Y output
3.2 Connect pulse cables and power adapter to the
Eyedro module.
1. Verify Package Contents 3. Install Hardware
Copyright © 2023, Eyedro Green Solutions Inc.
2. Record Serial Number:
(located under barcode on module)
_ _ _ - _ _ _ _ _
4. Create a MyEyedro User Account
4.1 Go to my.eyedro.com to create your online
account (or log in if you have an existing account).
4.2 Add the device to your user account:
go to Configuration, select Devices then enter the
serial number you recorded in Step 2.
4.3 ENJOY! Log into MyEyedro as often as you like to
view your electricity consumption.
4.4 For more details about the MyEyedro cloud service,
review the MyEyedro User Guide located at
eyedro.com/support