fantastic furniture KINGSTON User manual

AssemblyInstructions
KINGSTON
Bench
Ver1.1

Page 2
2
3
5
6
Read Instructions carefully.
Lay out all of the components on a soft surface
as if you were preparing to do a jigsaw puzzle.
Carefully identify each component, especially
those that are similar. The most common mistake
is getting things back to front.
Separate and identify each component from the
hardware pack and rest each one in its proper
W
A
R
N
N
G
WARNING
Check no parts are missing.
4
fully tighten screws（leave slightly
loose).When the item is fully assembled
tighten the screws - but do not over tighten.
FAILURE TO FOLLOW THESE BASIC STEPS CAN LEAD TO DAMAGE
THAT IS NOT COVERED BY YOUR WARRANTY
If glue is required DO NOT set until you are
certain that the parts belong together.

WhatyouNeed
To AssembletheBody
TableTop (P1)
Leg (P2)
Leg (P2)
Page3
Pleasemakesureyouhaveallthesepartsbeforeyou start
6xBolt
M8x60mm
(H2)
6xFlatWasher
Ø19 x2mm
(H3)
1xSpanner
13 x90 mm
(H1)
DONOTUSE
4xWoodendowel
Ø8x30 mm
(H4)

Page4
Step 1
Note: Assemblethe tableon asoft flat surfacetoprevent the benchtop
frombeing damaged during assembly.
Insert 4wooden dowels(H4)totheBenchtop(P1).
(P1)
(H4)
(H4)
(H4)
(H4)

Page5
Step 2
(P1)
(P2)
Position the Legs(P2)against the Benchtop (P1)sothe bolt holesline up.

Page6
Step 3
You will need:
6xBolt
M8x60mm
(H2)
6xFlat
Washer
Ø19 x1mm
(H3)
1xSpanner
13 x90 mm
(H1)
Fix2xLegs(P2)tothe Benchtop(P1)using 6xFlat Washer(H3)and 6xBolts(H2)withspanner(H1).
(P1)
(P2)
(H2)
(H3)
(H1)

Page7
Step 4
Turnthe Benchupright.
Thejobisnowcomplete!
Inthe interest of ourenviroment
Pleasedisposeof all the packagingthoughtfully.