Fellowes AERAMAX PRO AM2 User manual

AERAMAX®PRO AM2
Quick
Start
Guide

This guide is for machine set-up. For full installation guidelines, please refer to the product
documentation that came with the unit, or visit http://support.fellowes.com

AeraMax AM2 | 3
Welcome to
Healthy Air

4 | Setting Up
01
»Press the access panel latch located at the top of the unit
down while pulling the front panel towards you.
02
»Remove bag from lters.
Setting up your air purifier

AeraMax AM2 | 5
03
»Peel adhesive back on 4 corners of green pre-lter.
04
»Adhere pre-lter over the black carbon side of the hybrid
HEPA lter.

6 | Setting Up
05
»Align the AeraMax Pro Certied Filter stickers on the lter
and the inside of the unit.
»Insert lters and ensure the green pre-lter goes in rst. The
HEPA lter should be facing out.
06
»Close front panel. You will know it’s secure when you hear
a click.

AeraMax AM2 | 7
07
»Plug into an outlet and ensure the power switch located
at the bottom rear of the unit next to the power cord is
switched to the on position.
»The machine is now powered on and in auto mode.
08
»Once the unit is turned on, there is a 1 minute delay before
you can manually adjust the fan speed.
»You can adjust fan speed manually by pressing and holding
the fan icon until a beep is heard.
»The higher the beep pitch, the faster the fan speed.
Getting started

8 | Getting Started
09
»Ionizer will be o by default.
10
»To turn on the ionizer, hold down on ionizer icon until it
beeps, then release.

AeraMax AM2 | 9

10 | Setting Up