felton industries FELIGB2 User manual

WARNING: READ THE ASSEMBLING INSTRUCTIONS CAREFULLY BEFORE ASSEMBLING THE IN-GROUND BENCH SEAT WITH BACK REST.
Make sure to wear protecve gloves and foot protecon when installing and assembling this product. Unpack the unit and make sure all the components are
included before proceeding. This acvity requires two o more people as liing is involved. Please ensure bolts are only nger-ghtened during the assembling
process for exibility in lining up components. Securely ghten the bolts before anchoring the product to the ground.
2m- IN GROUND BENCH SEAT WITH BACK REST
(CODE No. FELIGB2)
ITEM PART DESCRIPTION QTY
IGBR1 SEAT FRAME 2
IGBR2 2000 mm.—SEATING PLANK 1
IGBR3 2000 mm.— BACK REST PLANK 1
IGBR4 M6x25mm. HEXAGONAL HEAD BOLT 12
IGBR5 M6 LOCKNUT 12
-
-
IGBR1 IGBR2 IGBR5
IGBR4
1
2
A. Place the seat plank (IGBR2) on a at surface and
aached it to the seat frame (IGBR1), by using hexag-
onal bolts (IGB4) and locknuts (IGB5) — nger ghten.
[IGBR1]
[IGBR1]
[IGBR4x4]
[IGBR5x4]
A. Aach the back rest plank (IGBR3) to the top of the seat frame plate
(IGBR1), by using hexagonal bolts (IGBR4) and lock nuts (IGBR5) - nger
ghten.
B. Tight both, the back rest and seat bolts with spans, wrench and /or a
proper tool.
IGBR3
[IGBR2]
[IGBR4x2]
[IGBR5x2]
[IGBR3]
[IGBR1]
P1
Hex bolt Lock nut
Back rest
ASSEMBLED BACK REST

WARNING: READ THE ASSEMBLING INSTRUCTIONS CAREFULLY BEFORE ASSEMBLING THE IN-GROUND BENCH SEAT WITH BACK REST.
Make sure to wear protecve gloves and foot protecon when installing and assembling this product. Unpack the unit and make sure all the components are
included before proceeding. This acvity requires two o more people as liing is involved. Please ensure bolts are only nger-ghtened during the assembling
process for exibility in lining up components. Securely ghten the bolts before anchoring the product to the ground.
3
GENERAL INSTALLATION RECOMMEDATIONS:
A. Turn the enre assembly upright and mark the locaon of the leg supports, according to the illustraon above.
B. Prepare the leg foundaon as necessary. Install seat legs accordingly.
C. We recommend to place at minimum 300 mm. of the seat legs in concrete.
P2