Felton Designer User manual

INSTALLATION GUIDE
Designer Slide Showers
Fit the cover buttons back onto the mounting
brackets, taking care to match the lug on the cover
to the notch in the bracket.
12
3 4
Slide Rail Installation
Carefully remove cover buttons from the mounting
brackets with a screwdriver as shown.
Fit the soap dish and slider onto the rail, sliding down
from the top of the rail as shown.
Select a location for the slide rail which is easily
reached and convenient for the user(s), preferably
over a wall stud or nog.
Using a level and the rail as a guide, mark and pre-drill
top and bottom mounting holes.
(If installing into wallboard or concrete, use toggles
provided by pre-drilling both top and bottom mounting
holes to 9.5mm diameter. Squeeze to close each
toggle and push in until ush with the wall).
5
Insert the screws provided through the mounting
brackets and into the pre-drilled holes. Tighten the
screws until the rail is rm against the wall.

010414KG
Felton Industries Limited guarantees its products to be free from defects in materials and workmanship for a period of
ve (5) years from the date of purchase. This warranty is effective for 5 years from the date of purchase and covers supply
of replacement parts only, not including installation.This warranty does not cover any damage to product due to abuse,
negligence or improper installation. Fair wear and tear is expressly excluded. This warranty is given on the understanding
that the product is installed and operated according to Felton’s installation guide.
Warranty, Maintenance & Care - Designer Slide Showers
Please ll in the details below, attach your receipt to this installation guide and keep as your proof of purchase.
Purchased at:
Date of purchase:
Installed by:
At no stage should plated surfaces be cleaned with cleaning agents that contain a corrosive acid
or a scouring additive. Plated surfaces should be cleaned with liquid detergent or soap and water.
Any damage caused through the use of an unsuitable cleaner will not be covered by warranty.
For technical assistance please ring: 0800 743 358 or [phone]
Felton Industries Limited - 8 Farmhouse Lane Glen Innes Auckland 1072 New Zealand www.felton.co.nz
Follow installation steps 1 - 5 above
6 7
Slip the plastic ange over the end of the elbow with
the black’o-ring’.
Screw the elbow into the water outlet (wingback).
Sealant required on thread to achieve a water tight
seal.
For Mains Pressure, fit flow restrictor into the
handpiece first.
Screw the hose onto the elbow and handpiece and
attach the handpiece to the slider on the rail.
132
Remove the shower head from
the existing Feltonmix wallset by
gripping the shower head stem
and turning it anti-clockwise.
Screw the elbow end with the black
‘o-ring’ into the wallset. The plastic
ange provided will not be needed
for this conversion.
For Mains Pressure, fit flow
restrictor into the handpiece first.
Screw the hose onto the elbow and
handpiece and attach the handpiece
to the slider on the rail.
Conversion from existing Feltonmix Wallset