Felton URBAN II U2HSKCSRGA User manual

INSTALLATION GUIDE - AUSTRALIA
URBAN II SINGLE SPRAY SLIDE SHOWER WHITE U2HSKCSRWA
URBAN II SINGLE SPRAY SLIDE SHOWER GUNMETAL U2HSKCSRGA
URBAN II SINGLE SPRAY SLIDE SHOWER BLACK U2HSKCSRBA
WHAT IS IN THE PACK
1 x Rail & Slider
2 x Wall Anchors
1 x Hose
2 x Screws
1 x Elbow
2 x Mounting
Bracket
1 x Single Spray
Handpiece
Rail can only be
installed with
the handpiece
on the right.
1 x Oxijet Water
Saving Product
(Optional)
1 x Flow Restrictor
& Sleeve
Warranty, Maintenance and Care YOUR COPY TO KEEP
Felton Australia Pty Limited guarantees these mixers to be free from defects in materials and workmanship for a period of five (5) years from the date of purchase. Fair wear and tear is
expressly excluded. This warranty is effective for five (5) years from the date of purchase and covers the supply of replacement parts only, not including installation. You must retain
proof of purchase of the Mixer (such as an invoice or receipt) and provide this to Felton on request. This warranty is for manufacturing defects only and does not cover any damage to
the product due to abuse, negligence or improper installation. This warranty is given on the understanding that the product is installed and operated according to Felton’s installation
guide and the Australian/New Zealand standard AS/NZS3500. This warranty is provided to persons who are defined as a “consumer” under the Australian Consumer Law only and for
use in domestic/residential dwellings only (not for commercial use).
At no stage should any surface coatings be cleaned with cleaning agents that contain a corrosive acid or a scouring additive. Surface coatings should be cleaned with
liquid detergent or soap and water. Any damage caused through the use of an unsuitable cleaner will not be covered by this warranty. This warranty is subject to any
other rights or remedies that you may have under the Australian Consumer Law (or any other applicable legislation) and to Felton’s Terms of Trade.
Please fill in the details below, attach your receipt to this installation guide and keep as your proof of purchase.
Purchased at: ...............................................................................................................................................................................................................................................................................................
Date of purchase: .......................................................................................................................................................................................................................................................................................
Installed by: ...................................................................................................................................................................................................................................................................................................
www.feltontapware.com.auPO Box 4191 Burwood East Victoria 3151, Australia
140617EI
For technical assistance please ring: 1800 792 760
Felton Australia Pty Ltd

It is essential that the
mounting brackets are
installed with the grub
screw hole facing the
right as shown.
Mount the rail onto the brackets in place. Ensure
that both rail and bracket are secured.
It is recommended that silicone sealant be used to
seal the fixing brackets.
Tighten the grub screw
on rail with an allen key.
685mm C-C
grub screw
hole
1. 3. 4.2.
HOW TO INSTALL
INSTALLING INTO STUD/NOG...(RECOMMENDED)
Untighten the grub
screw from the rail with
an allen key.
Remove the
brackets from the rail.
Mount the brackets into position (685 Centre -
Centre).
5. 8. 9.
INSTALLING INTO CONCRETE/BRICK WALL...
Pre-drill holes to 685 Centre - Centre
and fit the wall anchors then follow
the above instruction.
685mm C-C
Screw the elbow into the water outlet (wingback).
Sealant required on thread to achieve a water tight
seal. Fit flow restrictor into the handpiece first. Screw
the hose onto the elbow and handpiece and attach
the handpiece to the slider on the rail.