Felton WILLO III W3HSKCSRWA User manual

INSTALLATION GUIDE - AUSTRALIA
WILLO III SINGLE SPRAY SLIDE SHOWER WHITE W3HSKCSRWA
WILLO III SINGLE SPRAY SLIDE SHOWER GUNMETAL W3HSKCSRGA
WILLO III SINGLE SPRAY SLIDE SHOWER BLACK W3HSKCSRBA
WHAT IS IN THE PACK
1 x Rail & Slider
2 x Wall Anchors
1 x Hose
2 x Wall Screws
1 x Elbow
1 x Soap Dish
2 x End Posts and
Mounting Brackets
1 x Single Spray
Handpiece
Warranty, Maintenance and Care YOUR COPY TO KEEP
Felton Australia Pty Limited guarantees these mixers to be free from defects in materials and workmanship for a period of five (5) years from the date of purchase. Fair wear and tear is
expressly excluded. This warranty is effective for five (5) years from the date of purchase and covers the supply of replacement parts only, not including installation. You must retain
proof of purchase of the Mixer (such as an invoice or receipt) and provide this to Felton on request. This warranty is for manufacturing defects only and does not cover any damage to
the product due to abuse, negligence or improper installation. This warranty is given on the understanding that the product is installed and operated according to Felton’s installation
guide and the Australian/New Zealand standard AS/NZS3500. This warranty is provided to persons who are defined as a “consumer” under the Australian Consumer Law only and for
use in domestic/residential dwellings only (not for commercial use).
At no stage should any surface coatings be cleaned with cleaning agents that contain a corrosive acid or a scouring additive. Surface coatings should be cleaned with
liquid detergent or soap and water. Any damage caused through the use of an unsuitable cleaner will not be covered by this warranty. This warranty is subject to any
other rights or remedies that you may have under the Australian Consumer Law (or any other applicable legislation) and to Felton’s Terms of Trade.
Please fill in the details below, attach your receipt to this installation guide and keep as your proof of purchase.
Purchased at: ...............................................................................................................................................................................................................................................................................................
Date of purchase: .......................................................................................................................................................................................................................................................................................
Installed by: ...................................................................................................................................................................................................................................................................................................
Felton Australia Pty Ltd www.feltontapware.com.auPO Box 4191 Burwood East Victoria 3151, Australia
300517EI
For technical assistance please ring: 1800 792 760
1 x Flow Restrictor
& Sleeve

Secure brackets with bracket
screws and caps provided.
1. 3.
4.
2.
HOW TO INSTALL
INSTALLING INTO STUD/NOG...(RECOMMENDED)
Unscrew and separate the mounting
bracket from the end post.
Mount the mounting brackets into position
(731 mm Centre to Centre).
It is recommended that silicone sealant be used to
seal the fixing brackets.
Fit soap dish onto the
rail from the bottom then
fit both end posts.
Mount the rail onto the
mounting brackets in place.
5. 6.
INSTALLING INTO CONCRETE/BRICK WALL...
Pre-drill holes to 731 Centre - Centre
and fit the wall anchors then follow
the above instruction.
1
2
731mm C-C
731mm C-C
End post
Mounting
bracket
Screw the elbow into the water outlet (wingback). Sealant required on
thread to achieve a water tight seal. Fit flow restrictor to handpiece,
then screw the hose onto the elbow and handpiece and attach the
handpiece to the slider on the rail.