Felton ODYSSEY II User manual

For technical assistance please ring: 0800 743 358 or [phone]
Felton Industries Limited www.felton.co.nz8 Farmhouse Lane, Glen Innes, Auckland 1072 New Zealand
240920JC
Warranty, Maintenance and Care YOUR COPY TO KEEP
Felton Industries Limited guarantees these products to be free from defects in materials and workmanship for a period of five (5) years from the date of purchase.
This warranty is eective for 5 years from the date of purchase and covers supply of replacement parts only, not including installation. You must retain proof of purchase of the product
(such as an invoice or receipt) and provide this to Felton on request. This warranty is for manufacturing defects only and does not cover any damage to product due to abuse,
negligence or improper installation. This warranty is given on the understanding that the product is installed and operated according to Felton’s installation guide and the
Australian/New Zealand standard AS/NZS3500. This warranty is provided to persons who are a “consumer” under the Consumer Guarantees Act 1993 only and for use in
domestic/residential dwellings only (not for commercial use).
At no stage should plated surfaces be cleaned with cleaning agents that contain a corrosive acid or a scouring additive. Plated surfaces should be cleaned with liquid
detergent or soap and water. Any damage caused through the use of an unsuitable cleaner will not be covered by warranty.
This warranty is subject to any other rights or remedies that you may have under the Consumer Guarantees Act 1993 (or any other applicable legislation) and to Felton’s
Terms of Trade.
Please fill in the details below, attach your receipt to this installation guide and keep as your proof of purchase.
Purchased at: ...............................................................................................................................................................................................................................................................................................
Date of purchase: .......................................................................................................................................................................................................................................................................................
Installed by: ...................................................................................................................................................................................................................................................................................................
INSTALLATION GUIDE
ODYSSEY II SINGLE SPRAY SLIDE SHOWER O2CHSKCSR
WHAT IS IN THE PACK
2 x Wall Anchors
1 x Flow Restrictor
& Sleeve1 x Hose
2 x Screws
1 x Elbow
1 x Soap Dish
1 x Adjustable
Bracket
1 x Fixed
Bracket
1 x Single Spray
Handpiece

Hold the rail and
position the bottom
bracket into the desired
position (max distance
655mm C-C).
Screw the plastic
tightener into place.
Fit bracket caps.
Screw the elbow into the water outlet (wingback).
Sealant required on thread to achieve a water tight
seal. For Mains Pressure, fit flow restrictor into the
handpiece first. Screw the hose onto the elbow and
handpiece and attach the handpiece to the slider on
the rail.
1. 3. 4. 5.2.
Max 655 Centre - Centre
Max 655
HOW TO INSTALL
INSTALLING INTO STUD/NOG...(RECOMMENDED)
Remove the bracket
cap and unscrew the
plastic tightener.
Remove the
adjustable bracket from
the rail.
Mount the adjustable
bracket into the top
bracket position (either
into a new pre-drilled
hole or existing hole).
Fit soap dish onto the
rail from the bottom.
Slide the rail into the
top bracket.
6. 8. 9.7.
INSTALLING INTO CONCRETE/BRICK WALL...
Pre-drill holes to the desire position
(Max 655 Centre - Centre) and fit the
wall anchors then follow the above
instruction.
Mount the bottom bracket
into place. Ensure that
both rail and bracket are
secured. It is recommend-
ed that silicone sealant be
used to seal the fixing
brackets.