Berlin Gardens Bristol Dining Chairs User manual

Bristol Dining Chairs
Assembly Guide
Tools Required
Hardware Included
Cordless Drill #2 Square Drive Bit 5/32" Allen Drive Bit
(Included with Counter, Bar & XT Ht. Only)
Step 1
Fasten the back to the seat by fitting the
seat supports into the cutouts in the back legs.
Using the #2 square drive bit, drive
4 - 4" buglehead screws into the predrilled
holes in the back legs. You may need to reverse
your drill several times before being able
to pull the pieces tightly together.
Note: Ensure that the outside surfaces of the back leg
and seat support are even and are securily fastened
as noted below!
4 - 4" Buglehead Screws 4 - 2" Pandeck Screws
(Dining Ht. Only)
8 - 1/4" x 2" Lags
(Counter, Bar & XT Ht. Only)
Dining Counter Bar XT
Back & Seat Assembly Detail
4" Buglehead Screws
Ensure that the outside surfaces of both pieces are even and are securely fastened!

Step 2
For Dining Height Chairs Only
Fit the leg braces into the cutouts in
the lower parts of the chair legs as shown.
Fasten them by using the #2 square drive bit
and driving 4 - 2" pandeck screws into the
predrilled pocketholes.
Step 2
For Counter, Bar & XT Height Chairs Only Place the Footrest Assembly between
the chair legs. Align the predrilled
holes of the footrest with the predrilled
holes in the chair legs.
Using the 5/32 Allen Drive Bit, fasten
it using 8 - 1/4" x 2" Lags
.
You may need to reverse your drill
several times before you are able to
drive the lags in completely.
1/4 " x 2" Lag s
Leg Brace Attachment Detail
Footrest Attachment Detail
2" Pandeck Screws