FILTERMIST FT300 User manual

FT300
This tramp oil skimmer uses a rotating belt to remove tramp oil
floating on the surface of your cutting fluid. This unit is
designed to remove up to 3 litres per hour.
Belt width: 30mm
Max insertion depth: 150mm*
CONTENTS
•Oil Skimmer (240 volt)
•Standard belt (800 x 30mm)
INSTALLATION
•The oil skimmer should be mounted above the liquid
tank, preferably on the opposite side to the inlet.
•The skimmer can be fixed on top of the tank,
supported by the angle bracket pre-drilled to take 2 x
M6 fasteners.
•The base of the drive unit must be a minimum of
40mm above the top of the highest fluid level.
•A standard 19mm I/D hose can be fitted to the ‘V’
channel to take the waste to a suitable container.
•The unit can be plugged direct into a standard 240v,
50Hz supply.
•The belt should be attached with the green side on the
INSIDE.
ELECTRICAL SPECIFICATION
•240 volt single phase
•Motor rated at 3 watts 0.5 amps
WARNING
•This model is not designed for continuous running. Use up
to 8 hours maximum in any 24-hour period.
•Care must be taken to ensure that the motor housing and
electrical connections do not come into contact with any fluid.
•Oil leaks can be a hazard. Regularly empty waste oil from collection chamber and
inspect the oil return tube for any blockages or damage.
•Contact with oils, coolants etc. can cause skin disorders. Avoid contact with skin and
eyes and wear PVC, neoprene or nitrile gloves, safety glasses and overalls when
handling or cleaning the unit.
* Longer belts are available at extra cost.
Telford 54 Business Park
Nedge Hill
Telford TF3 3AL
England
Telephone: [phone]
Fax: [phone]
Email: [e-mail]
www.filtermist.co.uk

EC Declaration of Conformity /
Incorporation
Filtermist International Ltd declares that this machinery:
Model: FT300
Description: Tramp Oil Skimmer
Serial number: see unit Year of Manufacture: see unit
Conforms to EC Machinery Directive 2006/42/EC and Standard ISO 12100:2010
THIS TRAMP OIL SKIMMER MUST NOT BE PUT INTO SERVICE UNTIL THE RELEVANT
MACHINERY INTO WHICH IT IS TO BE INCORPORATED HAS BEEN DECLARED TO
CONFORM WITH THE PROVISIONS OF THE MACHINERY DIRECTIVE.
I hereby declare that the equipment named above has been tested and found to comply with
the relevant sections of the above referenced specifications. The unit complies with all
essential requirements of the Directives. The Technical Documentation has been drawn up
by the person named below and is held at our Head Office, Telford.
Name: J.R. Stansfield
Position: Director
Date of declaration: 2017
Place of issue: Filtermist International Limited, Telford 54 Business Park, Nedge Hill, Telford,
Shropshire, TF3 3AL
T: [phone] F: [phone]
E: [e-mail]
W: www.filtermist.co.uk