Fimco SK-61-12V-TSC Parts list manual

Page 1
2135827
MODEL NO. SK-61-12V-TSC
12 VOLT SKID MOUNTED LAWN & GARDEN SPRAYER
ASSEMBLY / OPERATION INSTRUCTIONS / PARTS
GENERAL INFORMATION
The purpose of this manual is to assist you in operating your
sprayer. Please read it carefully as it furnishes information
which will help you operate and maintain your sprayer.
Your authorized dealer is the best source of replacement

remember to give the following information.
1. Correct part description and part number.
2. Model number of your sprayer.
3. Serial number of your sprayer.
Part number and descriptions can be obtained from the
illustrated parts list section of this manual. Whenever you
need parts or repair service, contact your distributor / dealer
         
slip, or other evidence of purchase date, to your distributor
/ dealer.
TECHNICAL SPECIFICATIONS

• 12 Volt Diaphragm Pump - 2.1 G.P.M.
• Adjustable Pressure Range 0 - 60 P.S.I.



• Optional Trailer & Boom Kits Available
ASSEMBLY
The sprayer is fully assembled at the factory. The only as-
sembly necessary is to thread the pressure gauge in place,

The red wire of the two wire set must be connected to the

switch or to the ammeter. The brown wire may be grounded
or connected to the negative battery post.
OPERATION
The pump on the sprayer is factory set to shut off automati-
  
boom may be shut off at anytime when the pump system
is running. Pressure may be decreased by opening the
regulating valve. The more it is opened the lower the pres-
sure will be. The pump will not shut down as long as the
regulating valve is open.


 

DO NOT USE PUMP IN AN EXPLOSIVE
ENVIRONMENT. DO NOT USE TO PUMP
FLAMMABLE FLUIDS, GASOLINE,
KEROSENE FUEL, OIL, ETC.
WARNING
BEFORE RETURNING THIS PRODUCT
FOR ANY REASON, PLEASE CALL
1-800-831-0027
IF YOU SHOULD HAVE A QUESTION OR
EXPERIENCE A PROBLEM WITH YOUR
FIMCO INDUSTRIES PRODUCT:
1-800-831-0027
BEFORE YOU CALL, PLEASE HAVE THE
FOLLOWING INFORMATION AVAILABLE:
SALES RECEIPT & MODEL NUMBER. IN MOST
CASES, A FIMCO INDUSTRIES EMPLOYEE CAN
RESOLVE THE PROBLEM OVER THE PHONE.
WARRANTY / PARTS / SERVICE
Products are warranted for one year from date of purchase


Page 2

the strainer, and to the pump. The pump forces the solution
under pressure to the handgun.
It is important to test the sprayer with plain water before at-


-


to the pump. The valve is located on the inlet side of the
      

valve is in the "off" position.

screen and opening the valve, thus allowing the solution
to run out. The solution may be drained into a convenient
container.
WARNING: Some chemicals will damage the pump valves
         




valve and open the on-off valve. Turn on the garden hose


all waste water from the sprayer.
AFTER SPRAYING

and allow clear water to be pumped through the plumbing
system and out through the handgun. Use the handgun to

-
cal neutralizer such as NUTRA-SOLor equivalent and repeat


disposal instructions of all wash and rinsing water.
WINTER STORAGE
Drain all water out of the sprayer paying special attention to
pump, valves, and spray gun. These items are especially
prone to damage from chemicals and freezing weather.
The sprayer should be winterized before storage by pump-
ing a solution of RV anti-freeze through the entire plumb-
ing. Proper care and maintenance will prolong the life of
the sprayer.
PRESSURE SWITCH OPERATION
Pressure switch is pre-set at the factory. Improper
adjustment of the pressure switch, may cause severe overload or
premature failure. If the pump is subjected to rapid cycling during
normal operation, or infrequent periods, damage may occur.
CAUTION

Page 3

