FireplaceXtrordinair 564 25K User manual

564 25K & 35K Fireback Installation
96100191, 96100198, 96100199, 96100200, 96100201, 96100202 ,96100205
Page 1 of 6 17602188 - 12/15/22 Travis Industries, Inc.
Compatibility
564 25K
564 CF 25K
564 35K
564 CF 35K
For 564 fireplaces built prior to those listed above (2019), floor firebacks (250-03768) may be needed to
complete the installation. Contact Travis Industries for details.
Packing List
Rear Fireback
(2) Side Firebacks
The firebacks are fragile (especially the rear fireback). Take care when handling the firebacks.
WARNING Turn off the gas to the appliance and make sure it has fully cooled prior to conducting service.
Standard and CleanFace Fireback Installation
NOTE: If using an optional fireback install the kit before performing any other firebox setup.
WARNING: Turn off the gas to the appliance and make sure it has fully cooled prior to conducting service.
NOTE On two-sided firebacks make sure to use the desired pattern.
1. Remove the glass frame and logs (see the installation manual for details).
2. The firebox baffle and exhaust restrictor must be removed to install firebacks (replace them once the
firebacks are in place).
FireboxCeiling
The baffle and exhaust restrictor have keyholes, allowing
removal without removing the screws.
Firebox Baffle

564 25K & 35K Fireback Installation
96100191, 96100198, 96100199, 96100200, 96100201, 96100202 ,96100205
Page 2 of 6 17602188 - 12/15/22 Travis Industries, Inc.
3. Remove the rear burner. Lift the rear burner straight up and remove it from the firebox.
NOTE: there is a pin in each of the rear corners of the burner that hold the burner in the correct position.
When replacing the burner make sure the pines are inserted into the holes on the rear feet of the burner.
4. Use a ¼” nut driver to remove the two screws that secure the rear air deflector to the fireplace (Set the
screws aside for reinstallation).

564 25K & 35K Fireback Installation
96100191, 96100198, 96100199, 96100200, 96100201, 96100202 ,96100205
Page 3 of 6 17602188 - 12/15/22 Travis Industries, Inc.
5. Lift the rear air deflector straight up and remove it from the firebox.
6. Remove the hearth front cover. Lift the cover and remove it from the firebox. Set the cover aside for
reinstallation.

564 25K & 35K Fireback Installation
96100191, 96100198, 96100199, 96100200, 96100201, 96100202 ,96100205
Page 4 of 6 17602188 - 12/15/22 Travis Industries, Inc.
7. All firebacks except black glass = Remove and discard the media tray covers.
Black glass firebacks = Remove and keep the media tray covers for reinstallation.
8. Remove the (2) fireback clips (one on each side). Use a 1/4” nut driver to loosen the screws that
secure the fireback clips to the ceiling of the fireplace. The clips have key-hole slots in them so with
the screws loosened, slide the clips toward the center of the fireplace and then lower the clip over the
head of the screws. Set the clips aside for reinstallation.

564 25K & 35K Fireback Installation
96100191, 96100198, 96100199, 96100200, 96100201, 96100202 ,96100205
Page 5 of 6 17602188 - 12/15/22 Travis Industries, Inc.
9. Place the rear fireback in position. Tilt the bottom of the fireback toward the rear wall of the firebox. Set the
bottom of the fireback on the bent-out tabs on the rear of the media tray. The side firebacks installed in the
next step will hold the rear fireback in place so, make sure to support the rear fireback until the side firebacks
are installed.
10. Install the side firebacks. Tilt the firebacks so the bottom edge fits past the ends of the media tray. Set
the fireback on the trays bent out tabs. Tilt the upper edge of the firebacks toward the fireplace wall until
they are vertical.

564 25K & 35K Fireback Installation
96100191, 96100198, 96100199, 96100200, 96100201, 96100202 ,96100205
Page 6 of 6 17602188 - 12/15/22 Travis Industries, Inc.
11. Install the retaining clips on both sides to hold the side firebacks in place.
12. Restore the fireplace to the correct configuration.
If using black glass firebacks reinstall the media tray covers. Slide the media tray
covers to the outside to cover the gap between the media tray and the fireback panels.
For all other firebacks, you may discard the covers.
Black Glass Firebacks All other Firebacks