Fisher-Price Bubble Mower User manual

®
Fisher-Price
Bubble Mower
• Please save these instructions for future reference.
• Adult assembly is required.
• No tools needed for assembly.
Message to Parents
• Please make sure your child does not follow you using the Bubble Mower while you are operating a real lawnmower.
Also, your child should play in a separate area away from the area where you are mowing.
• Please make sure your child understands that only bubble solution should be used in the Bubble Mower.
• Please make sure your child understands that bubble solution is not for drinking and that it should be kept away from
the eyes.
• While filling or cleaning the Bubble Mower, try to avoid spilling bubble solution on the floor. It may create slippery floor
conditions.
• Do not spill bubble solution on detergent-sensitive surfaces.
®
Fisher-Price
Instructions
If you have any questions about this product, please call Fisher-Price Consumer Affairs, toll-free at 1-800-432-KIDS
(1-800-432-5437) between 8 AM and 6 PM Eastern time, Monday through Friday, or write to:
Fisher-Price, Inc.
Attn: Consumer Affairs
636 Girard Avenue
East Aurora, New York 14052
Hearing-impaired consumers using TTY/TDD equipment, please call 1-800-382-7470.

• Lift the handle until it snaps into an upright position.
PLEASE NOTE: Make sure the tabs at the ends of the
handle fit into the slots near the rear wheels when the
handle is raised. If the tabs do not fit into the slots,
remove the handle and repeat steps and .
Handle
• Pour bubble solution into the mower spout. For refills,
use commercial bubble solution.
Use
Spout
©1995 Fisher-Price Inc., East Aurora, New York 14052 2022 6 72022-0920
Storage
Clean-Up
• Tip the Bubble Mower on its side to empty the
bubble chamber.
• Discard the bubble solution.
• Place the spout under a water faucet or a garden
hose spigot.
• Run clean water into the spout, rotate the back wheels
a few times, then pour the water out.
• Repeat this procedure if necessary.
Spout
• To remove the handle, lower the handle. Pull the ends
of the handle outward to remove the handle from
the mower.
• Rinse the Bubble Mower thoroughly with clean water
before storing it for long periods of time.
Handle
• Place the mower on a flat surface.
• Position the handle with the Fisher-Price logo
facing up.
• With the handle angled down, slide the hole on one
side of the handle onto the peg near the rear wheel.
• Fit the hole on the other side of the handle onto the
peg near the other rear wheel.
Handle
Mower
®
Fisher-Price
• Bubbles will begin flowing after the Bubble Mower
has been pushed about 15-20 walking steps. As long
as the Bubble Mower is being pushed, the bubbles
continue.
• When using the Bubble Mower with bubble solution,
we recommend using it outdoors on a flat surface or in
short grass.
• If your Bubble Mower does not make bubbles:
-Check to be sure there is enough bubble solution
in the Bubble Mower.
-Empty the bubble solution from the Bubble Mower.
Fill the Bubble Mower with fresh bubble solution.
-Wash the bubble chamber (see “Clean-Up”).
PLEASE NOTE: We do not recommend the use of
silicones or oily lubricants on this product. As with any
bubble producing toy, when even a very small amount of
silicone or oily lubricants are put into or used near the
bubble chamber, bubbles will not form.
Assembly
Hole
Peg
1
2
1
2