Fisher-Price DMR88 User manual

1
DMR88
fisher-price.co.uk
IMPORTANT! KEEP FOR FUTURE REFERENCE.
Please read these instructions before assembly and use of this product.
Do not adjust the seat recline with child in the seat.

2
Consumer Information
WARNING
Prevent serious injury or death:
• Never leave the child unattended.
• It is dangerous to use this product on an elevated surface, e.g. a table.
• This product is not intended for prolonged periods of sleeping.
• Suffocation Hazard: Never use on a soft surface (bed, cot, sofa,
cushion), since the product can tip over and cause suffocation in
soft surfaces.
• Never use the toy bar to carry the product.
• Never use as a carrier or lift while child is seated.
• When used in the recline position (reclined cradle mode):
- Use until child weighs 9 kg or is able to sit up unaided.
- Do not use the reclined cradle once your child can sit unaided.
- Always use the restraint system.
• When used in the upright position (toddler mode):
- Use only with a child who is able to sit up unaided and weighs more
than 9 kg.
- Always use the restraint system until child can climb in and out of the
product unaided.
IMPORTANT! Before assembly and each use,
inspect this product for damaged hardware,
loose joints, missing parts or sharp edges.
Do not use the product if any components are
broken or missing. Do not use accessories or
replacement parts other than those approved
by the manufacturer.
• Adult assembly is required.
• Tool needed for assembly: Phillips
screwdriver (not included).
• Requires two C (LR14) alkaline batteries
(not included) for soother operation.
• Use the product from birth until child
weighs 18 kg
• Recline position (recline cradle mode) -
maximum weight of child: 9 kg
• This product does not replace a cot or a
bed. Should your child need to sleep, then it
should be placed in a suitable cot or bed.
• Product features and decorations may vary
from photographs.

3
M4,5 x 20 mm Screw - 6
Shown Actual Size
Soothing Unit
IMPORTANT! Please remove all parts from the
package and identify them before assembly.
Some parts may be packed in the pad.
Parts
Pad
(Pad includes a Seat Back
Tube inside the sleeve and
a tethered brace)
Hint: Please refer to the
care section to remove the
seat back tube for cleaning.
Note: Tighten or loosen the screws with a Phillips
screwdriver.Do not over-tighten the screws.
Toy Bar
2 Side Rails
Pa
(P
Tu
a
t
Hi
ca
se
1
2
Side Rail
• Lift the long and short end of each side rail.
• Fit the soothing unit into the slots in each
side rail.
Hint: The soothing unit is designed to fit one
way. If it does not seem to fit, turn it around
and try again.
Soothing Unit
BOTTOM VIEW
Assembly

4
3
Assembly
• Insert four screws into the soothing unit
and tighten.
4
• Fit the rear cross brace (attached to the pad)
onto each side rail.
Rear Cross Brace
6
5
• Insert two screws into the rear cross brace
and tighten.
• Turn the assembly upright.
• Fit the free end of each hinged rail into the
socket in the opposite end of each side rail.
• Push to "click" each rail in place.
SIDE VIEW
6

5
Assembly
7
• Insert the ends of the seat back tube (inside
the pad) into the sockets in the side rails.
• Push down on the seat back tube until you
hear a “click” on each side.
• Pull up on the seat back tube to be sure it
is secure.
Seat Back Tube
(inside pad)
8
• Insert and “snap” the pegs on the front and
sides of the pad into the holes in the soothing
unit and side rails.
SIDE VIEW
SIDE VIEW
FRONT VIEW
FRONT VIEW
• Insert and “snap” the toy bar plugs into each
retainer socket. The toy bar is designed to
fit one way. If it does not seem to fit, turn it
around and try again.
Hint: The toy bar is removable. Press the ends
of the latches and lift the toy bar.
9
Toy Bar

6
©2016 Mattel. All Rights Reserved. DMR88-ZZ72
PRINTED IN CHINA 1100801612-UU1
Great Britain: Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk.
Mattel Europa B.V., Gondel 1,
1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658
Church Street, Locked Bag #870, Richmond,
Victoria 3121 Australia. Consumer Advisory
Service 1300 135 312.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
Asia: Mattel East Asia Ltd., Room 503-09,
North Tower, World Finance Centre,
Harbour City, Tsimshatsui, HK, China.
Tel.: [phone].
Malaysia: Diimport & Diedarkan Oleh:
Mattel Southeast Asia Pte. Ltd., No 19-1,
Tower 3 Avenue 7, Bangsar South City, No 8,
Jalan Kerinchi, 59200 Kuala Lumpur, Malaysia.
Tel: [phone], Fax: [phone].

7
Battery Installation
• For longer life, use alkaline batteries.
• Loosen the screw in the battery compartment
door and remove the door.
• Insert two, new C (LR14) alkaline batteries.
• Replace the battery compartment door and
tighten the screw.
• If this product begins to operate erratically,
you may need to reset the electronics.
Remove the batteries and reinstall them.
• If vibrations become faint or there are no
vibrations at all, remove the batteries from
the battery compartment and dispose of them
properly. Replace the batteries with two, new
C (LR14) alkaline batteries.
1,5V x 2
C (LR14)
• Protect the environment by not
disposing of this product with
household waste (2012/19/EU).
Check your local authority for
recycling advice and facilities.
Battery Safety Information
In exceptional circumstances, batteries may
leak fluids that can cause a chemical burn
injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or batteries
of different types: alkaline, standard (carbon-
zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods of
non-use. Always remove exhausted batteries
from the product. Dispose of batteries safely.
Do not dispose of this product in a fire. The
batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent
type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
product before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.

8
Setup and Use
WARNING
Prevent serious injury or death:
• Never leave the child unattended.
• It is dangerous to use this product on an elevated surface, e.g. a table.
• This product is not intended for prolonged periods of sleeping.
• Suffocation Hazard: Never use on a soft surface (bed, cot, sofa,
cushion), since the product can tip over and cause suffocation in
soft surfaces.
• Never use the toy bar to carry the product.
• Never use as a carrier or lift while child is seated.
• When used in the recline position (reclined cradle mode):
- Use until child weighs 9 kg or is able to sit up unaided.
- Do not use the reclined cradle once your child can sit unaided.
- Always use the restraint system.
• When used in the upright position (toddler mode):
- Use only with a child who is able to sit up unaided and weighs more
than 9 kg.
- Always use the restraint system until child can climb in and out of the
product unaided.

9
Extend Frame
• Lift the seat back to extend the frame for
toddler use.
Shorten Frame
• While pressing the buttons on the back of the
side rails, push the seat back to shorten the
frame for newborn or older baby use.
Setup and Use

10
Seat
• Rotate each kickstand down to use as
a stationary seat.
Rocker
• Rotate each kickstand up to use as a rocker.
Upright
• Lift the seat back and fasten the straps on
the back of the seat. Make sure you hear
a “click”.
Recline
• Unfasten the straps on the back of the seat
and lower the seat back.
Straps
Straps
click”
.
Straps
Straps
Setup and Use