Fisher-Price Barbie SMART T5407 Use and care manual

Please read this manual and save•
it with your original sales receipt.
Tool needed for assembly: Phillips•
screwdriver (not included).
Use only with the Power Wheels• ®
12 Volt Lead-Acid Rechargeable
Orange Battery with Built-in Thermal
Fuse and the Power Wheels®12 Volt
Charger (both included).
Owner's Manual
Owner's Manual
with Assembly Instructions
with Assembly Instructions
For Model T5407
For Model T5407

2
T5407pr-0920
IMPORTANT INFORMATION
ELECTRICAL HAZARD
RIDING HAZARD
• To prevent electric shock, do not immerse in water; wipe clean with a damp cloth.
DANGER
WARNING
WARNING
Battery can fall out and injure a child if vehicle tips over. Always use battery retainer.•
PREVENT FIRE•
- Never modify the electrical system. Alterations could cause a re resulting in
serious injury and could also ruin the electrical system.
- Use of the wrong type battery or charger could cause a re or explosion resulting
in serious injury.
- Use of Power Wheels®components in products other than Power Wheels®
vehicles could cause overheating, re or explosion.
The battery must be handled by adults only. The battery is heavy and contains•
sulfuric acid (electrolyte). Dropping the battery could result in serious injury.
Never allow children to charge the battery. Battery charging must be done by adults•
only. A child could be injured by the electricity involved in charging the battery.
Read the safety instructions on the battery.•
Examine the battery, charger and their connectors for excessive wear or damage•
each time you charge the battery. If damage or excessive wear is detected, do not
use the charger or the battery until you have replaced the worn or damaged part.
HOT• motors. Handle carefully.
Prevent Injuries and Deaths•
Direct Adult Supervision Required.•
Never Ride at Night.•
Keep Children Within Safe Riding Areas.•
These areas must be:
Away from swimming pools and other bodies of water to prevent drownings.-
Generally level to prevent tipovers.-
Away from steps, steep inclines, cars, roads and alleys.-
Riding Rules•
Make sure children know and follow these rules for safe driving and riding.
Always sit on the seat.-
Always wear shoes.-
Only 2 (two) riders at a time.-

3T5407pr-0920
IMPORTANT INFORMATION
Read this manual carefully for important safety•
information and operating instructions before using
your vehicle. Keep this manual for future reference,
as it contains important information.
The vehicle is designed for use on grass, asphalt, and•
other hard surfaces; on generally level terrain; and by
children 3 years of age and older. Do not exceed the
maximum weight capacity of 130 lbs (59 kg).
Your new vehicle requires adult assembly. Please set•
aside at least 30 minutes for assembly.
Use this vehicle• ONLY outdoors. Most interior flooring
can be damaged by riding this vehicle indoors.
Fisher-Price®will not be responsible for damage
to the floor if the vehicle is used indoors.
You must charge your battery for 18-30 hours• before
you use your vehicle for the first time. We recommend
charging your battery before beginning assembly. Please
see the Battery Charging section for detailed instructions.
The battery charger is not a toy.•
Do not short circuit the battery.•
Adults Note:• Regularly examine the charger for damage
to the cord, plug, housing or other parts that may result
in the risk of fire, electric shock or injury. In the event
of any damage, do not use the charger until the damage
has been properly repaired.
Your Power Wheels• ®12 volt battery is equipped
with a built-in thermal fuse. The thermal fuse is
a self-resetting safety device which automatically “trips”
and shuts down operation of the vehicle if the vehicle is
overloaded or the driving conditions too severe. Once
a fuse has “tripped”, remove your foot from the pedal
and wait approximately 25 seconds before operating the
vehicle again. To avoid repeated automatic shut-downs,
avoid severe driving conditions.
If a thermal fuse in a battery continually trips under•
normal driving conditions, please contact your local
Power Wheels®Authorized Service Center.
To prevent damaging the motors and gears, teach your•
child to stop the vehicle before switching direction.
If you have any questions about your Power Wheels• ®
vehicle, please call our toll-free service lines at
1-800-348-0751. Trained customer service
representatives are available to take your call in English
or French. Habla Español? Si usted tiene alguna pregunta
ó necesita asistencia llame gratis 1-800-348-0755 para
los Estados Unidos. Tenemos representantes que hablan
español para atender su llamada.
For your convenience, Power Wheels• ®maintains an
independently owned and operated Authorized Service
Center Network with more than 300 authorized service
centers nationwide. Our authorized service centers
will repair or replace parts under warranty at no extra
charge, and can perform non-warranty repairs for
a minimal charge. To find the authorized service center
nearest you, please visit us on-line at
www.powerwheels.com or call 1-800-348-0751.
Please visit us online to register your vehicle.•

4
T5407pr-0920
If you experience a problem with this product, please call us at• 1-800-348-0751, rather than return this product
to a store.
Please identify all parts before assembly and save all packaging material until assembly is complete to ensure that no•
parts are discarded.
Metal parts have been coated with a lubricant to protect them during shipment. Wipe all metal parts with a paper•
towel to remove any excess lubricant.
Vehicle
Roll Bar
Dash
Windshield
Seat Back
Steering Column Cap 2 Side Supports
Steering Wheel Assembly
12 Volt Orange Battery 12 Volt Charger
Seat Bottom
#8 x ¾"(1,9 cm) Screw – 16
Fastener Shown Actual Size
For your convenience, we included an extra fastener!
Tighten and loosen all screws with a Phillips
screwdriver. Do not over-tighten the screws.
PARTS

5T5407pr-0920
ASSEMBLED PARTS
Note: Fasteners not shown.

6
T5407pr-0920
ELECTRICAL HAZARD
WARNING
CAUTION
Make sure you charge the battery for at least 18 hours•
using the enclosed Power Wheels®12 volt charger
before operating your vehicle for the first time. Charge
the battery for at least 14 hours after each use of the
vehicle. Never charge the battery longer than 30 hours.
Failure to follow these instructions may damage your
battery and will void your warranty.
Use only a Power Wheels• ®12 volt charger with “12V”
connector (input 120 VAC, 60Hz, with an output of 12
VDC) to charge your Power Wheels®12 volt battery.
Plug the charger connector into the battery socket.•
Plug the charger into a standard wall outlet.•
Notes:
If power flow to the wall outlet is controlled by-
a switch, make sure the switch is “ON”.
Use the charger only in a wall outlet. Do not plug the-
charger into a ceiling outlet.
Once the battery is charged, disconnect the battery•
connector from the charger connector. Unplug the
charger from the wall outlet. Refer to the Battery
Installation section for instructions on installing your
battery. If your battery is already installed in your
vehicle, simply re-connect the motor harness connector
to the battery.
You do not need to remove the battery from your vehicle•
to recharge it.
Do not charge the battery on a surface (such as a kitchen•
counter top) which could be damaged by the acid
contained inside the battery. Take precautions to protect
the surface on which you charge your battery.
Battery must be upright
while charging
Charger
Connector
BATTERY CHARGING
Battery can fall out and injure•
a child if vehicle tips over.
Always use battery retainer.
PREVENT FIRE•
- Never modify the electrical system.
Alterations could cause a re
resulting in serious injury and could
also ruin the electrical system.
- Use of the wrong type battery
or charger could cause a re or
explosion resulting in serious injury.
- Use of Power Wheels®components
in products other than Power
Wheels®vehicles could cause
overheating, re or explosion.
The battery must be handled•
by adults only. The battery is
heavy and contains sulfuric acid
(electrolyte). Dropping the battery
could result in serious injury.
Never allow children to charge the•
battery. Battery charging must be
done by adults only. A child could
be injured by the electricity involved
in charging the battery.
Read the safety instructions on•
the battery.
Examine the battery, charger and•
their connectors for excessive wear
or damage each time you charge
the battery. If damage or excessive
wear is detected, do not use the
charger or the battery until you have
replaced the worn or damaged part.
Use the charger in dry locations only.

7T5407pr-0920
BOTTOM VIEW
Children can be harmed by small
parts, sharp edges and sharp points
in the vehicle’s unassembled state,
or by electrical items. Care should be
taken in unpacking and assembly of
the vehicle. Children should not handle
parts, including the battery,
or help in assembly of the vehicle.
WARNING
Turn the vehicle upside down.•
Fit a side support onto a peg on the vehicle.•
Hint: The side support is designed to fit one way. If it
does not seem to fit, turn it around and try again.
Insert a screw through the side of the vehicle and into•
the side support. Tighten the screw.
Insert a screw through the side support and into the•
bottom of the vehicle. Tighten the screw.
Repeat this procedure to assemble the remaining•
side support on the other side of the vehicle.
A cardboard packer was placed in the front end of•
the vehicle to protect it during shipment. Remove
the cardboard packer and throw it away.
Hint: You may need to fold or crush the cardboard packer
before removing it from the vehicle.
Turn the vehicle upright.•
Vehicle
Screws
Side Support Vehicle Peg
Cardboard
Packer
Fit the dash onto the posts on the windshield,•
as shown.
Hint: The dash is designed to fit on the windshield one
way. If it does not seem to fit, turn it around and try again.
Insert two screws into the holes in the dash assembly.•
Tighten the screws.
Dash
Windshield
ASSEMBLY
1
4
5
2
3
Screws

8
T5407pr-0920
Insert two screws into the dash assembly. Tighten•
the screws.
Fit the steering column assembly down through the•
opening in the dash.
At an angle, fit the tabs on the dash assembly into the•
slots in the vehicle.
Dash Assembly
Steering Wheel Assembly
Carefully turn the vehicle on its side.•
Fit the end of the steering column through the hole in•
the steering linkage.
Fit the steering column cap onto the end of the•
steering column.
Insert a screw into the hole in the steering column cap.•
Tighten the screw.
Turn the vehicle upright.•
Steering
Column Cap
ASSEMBLY
6
9
10
7
8
BACK VIEW
Screws
BOTTOM VIEW
Screw
Place the seat back onto the vehicle, as shown.•
Seat Back
11
FRONT VIEW

9T5407pr-0920
Insert three screws into the holes in the seat back•
and tighten.
Fit the tabs on the roll bar onto the seat back and•
vehicle, as shown.
Insert four screws into the holes in the roll bar•
and tighten.
Roll Bar
Note: You may want to install the battery before
completing this step. Refer to the Battery Installation
section for instructions.
Fit the tabs on the seat bottom into the openings near•
the seat back.
Push the front edge of the seat down to• “snap” the seat
in place.
Seat Bottom
ASSEMBLY
12
13
14
15
Screws Screws
TOP VIEW
FRONT VIEW
TOP VIEW

10
T5407pr-0920
Wipe the vehicle with a clean, dry cloth to remove any oils before applying labels.•
Apply labels exactly as shown in the illustrations. For best results, avoid repositioning the label after it has been applied.•
Starting at the center of a label rub firmly with a dry cloth, and smooth towards the outer edges to remove air bubbles.•
12
2627
23
28
2
21
19
9
20
15
30
4 3
10
5 6 7 8
1
BACK VIEW
FRONT VIEW
DECORATION