Fisher-Price H5924c User manual

www.fisher-price.com
Please keep this instruction sheet for future reference,
as it contains important information.
Requires three "AA" (LR6) alkaline batteries (not included).
Adult assembly is required.
Tool required for assembly:
Phillips screwdriver (not included).

Neck
Tail Body
Parts
#6 x 11/2" (3.8 cm) Screw - 2
Shown Actual Size
Note: Tighten or loosen
all screws with a Phillips
screwdriver. Do not over-
tighten the screws.
3 Toys
This toy contains small parts in its unassembled state.
Adult assembly is required.
CAUTION
Head
4 Balls

Assembly
• Slide the tail onto the body.
• Slide the neck onto the body.
• "Snap" the toys into the body.
1
2
• Turn the assembly around.
• Insert two screws into the body
and tighten.
3
• "Snap" the head onto the neck.
4
Neck
Tail
Body

Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2007 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
PRINTED IN CHINA H5924c-0920
In exceptional circumstances, batteries
may leak fluids that can cause a
chemical burn injury or ruin your toy.
To avoid battery leakage:
• Do not mix old and new batteries
or batteries of different types:
alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium).
• Insert batteries as indicated inside
the battery compartment.
• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the toy. Dispose of
batteries safely. Do not dispose of this
product in a fire. The batteries inside
may explode or leak.
• Never short-circuit the battery
terminals.
• Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable
batteries.
• Remove rechargeable batteries from
the toy before charging.
• If removable, rechargeable batteries
are used, they are only to be charged
under adult supervision.
Battery Safety
Information
Battery
Installation
• Locate the battery compartment on
the back of the toy.
• Loosen the screws in the battery
compartment door. Remove the
battery compartment door.
• Insert three "AA" (LR6) alkaline batteries.
Hint: We recommend using alkaline
batteries for longer battery life.
• Replace the battery compartment door
and tighten the screws.
• When lights or sounds from this toy
become faint or stop, it’s time for an
adult to change the batteries!
1.5V x 3
“AA” (LR6)
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities
(Europe only).

Music, Lights and Rolling Action!
• Slide the power/volume switch to on with low volume ; on with
high volume or off O.
• Drop balls into the holes or down the ramps for fun music, lights and
dino sounds.
Peek-a-Boo
Door
Balls Roll Out
the Chute
Dino Mouth
Opens as Balls
Roll Out
Wiggly Friend
Colorful Lights
Spinning
Butterfly
Power/Volume
Switch

• Wipe this toy with a clean cloth dampened with a mild soap and water solution.
Do not immerse this toy.
• This toy has no consumer serviceable parts. Do not take this toy apart.
Care
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manufacturer
responsible for compliance could void the user’s authority to operate the equipment.
FCC Statement (United States Only)