Fisher-Price X0057 User manual

Please keep this instruction sheet for future reference, as it contains important information.
Requires three “AA” (LR6) alkaline batteries (not included) for operation.
Adult assembly is required.
Tool required for assembly: Phillips screwdriver (not included).
Actual product may appear different from the photos.
X0057
fisher-price.com

2
Care
•Wipethistoywithacleanclothdampenedwithamildsoap
andwatersolution.Donotimmersethistoy.
•Thistoyhasnoconsumerserviceableparts.Donottakethis
toyapart.
FCC Statement (United States Only)
Thisequipmenthasbeentestedandfoundtocomplywiththe
limitsforaClassBdigitaldevice,pursuanttoPart15ofthe
FCCRules.Theselimitsaredesignedtoprovidereasonable
protectionagainstharmfulinterferenceinaresidential
installation.Thisequipmentgenerates,usesandcanradiateradio
frequencyenergyand,ifnotinstalledandusedinaccordance
withtheinstructions,maycauseharmfulinterferencetoradio
communications.However,thereisnoguaranteethatinterference
willnotoccurinaparticularinstallation.Ifthisequipmentdoes
causeharmfulinterferencetoradioortelevisionreception,which
canbedeterminedbyturningtheequipmentoffandon,theuser
isencouragedtotrytocorrecttheinterferencebyoneormore
ofthefollowingmeasures:
•Reorientorrelocatethereceivingantenna.
•Increasetheseparationbetweentheequipmentandreceiver.
• Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
Note:Changesormodificationsnotexpresslyapprovedbythe
manufacturerresponsibleforcompliancecouldvoidtheuser’s
authoritytooperatetheequipment.
ThisdevicecomplieswithPart15oftheFCCRules.Operation
issubjecttothefollowingtwoconditions:(1)thisdevicemay
notcauseharmfulinterferenceand(2)thisdevicemustaccept
anyinterferencereceived,includinginterferencethatmay
causeundesiredoperation.
ICES-003
•ThisClassBdigitalapparatuscomplieswithCanadian
ICES-003.Operationissubjecttothefollowingtwoconditions:
(1)thisdevicemaynotcauseharmfulinterferenceand
(2)thisdevicemustacceptanyinterferencereceived,
includinginterferencethatmaycauseundesiredoperation.
NMB-003
•CetappareilnumériquedelaclasseBestconformeàla
normeNMB-003duCanada.L’utilisationdecedispositifest
autoriséeseulementauxconditionssuivantes:(1)ilnedoit
pasproduiredebrouillageet(2)l’utilisateurdudispositif
doitêtreprêtàacceptertoutbrouillageradioélectriquereçu,
mêmesicebrouillageestsusceptibledecompromettrele
fonctionnementdudispositif.
CONSUMER ASSISTANCE
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa B.V., Gondel 1, 1186MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
©2012Mattel.AllRightsReserved.
PRINTED IN MEXICO X0057a-0920
Consumer Information

3
CAUTION
This package contains small parts.
For adult assembly only.
3 Bases
Upper Wall Lower Wall
Assembled Parts Battery Installation
Long RampPart not shown: Label Sheet
Battery Safety Information
Inexceptionalcircumstances,batteriesmayleakfluidsthatcan
causeachemicalburninjuryorruinyourproduct.Toavoid
batteryleakage:
•Donotmixoldandnewbatteriesorbatteriesofdifferent
types:alkaline,standard(carbon-zinc)orrechargeable
(nickel-cadmium).
•Insertbatteriesasindicatedinsidethebatterycompartment.
•Removebatteriesduringlongperiodsofnon-use.Always
removeexhaustedbatteriesfromtheproduct.Disposeof
batteriessafely.Donotdisposeofthisproductinafire.The
batteriesinsidemayexplodeorleak.
•Nevershort-circuitthebatteryterminals.
•Useonlybatteriesofthesameorequivalenttype,
asrecommended.
•Donotchargenon-rechargeablebatteries.
•Removerechargeablebatteriesfromtheproductbeforecharging.
•Ifremovable,rechargeablebatteriesareused,theyareonlyto
bechargedunderadultsupervision.
•Locatethebatterycompartmentonthebottomofthetoy.
•Loosenthescrewinthebatterycompartmentdoorand
removethedoor.
•Insertthree,new“AA”(LR6)alkalinebatteries.
Hint: We recommend alkaline batteries for longer battery life.
•Replacethebatterycompartmentdoorandtightenthescrew.
•Ifthisproductbeginstooperateerratically,youmayneedto
resettheelectronics.Slidethepowerswitchoffandbackon.
•Whensoundsfromthistoybecomefaintorstop,it’stimefor
anadulttochangethebatteries.
1,5V x 3
“AA” (LR6)
•Protecttheenvironmentbynotdisposingofthis
productwithhouseholdwaste(2002/96/EC).Check
yourlocalauthorityforrecyclingadviceandfacilities.
Screwshownactualsize.Tightenorloosenallscrewswith
aPhillipsscrewdriver.Donotover-tightenthescrews.
Shown Actual Size
#8 x " (1,6 cm) Screw – 8
Arch 2 Flags Loop-the-Loop Ramp
3 Ramps
(Labeled 1)
Ramp
(Labeled 2)
Ramp
(Labeled 3)
Top Ramp

4
2
1
Upper Wall
Lower Wall
Assembly
Base Base
Arch
•Fitthearchontothewall,asshown.Insertascrewintothe
archandtighten.
•Fittheupperandlowerwallstogether,asshown.
•Insertfourscrewsintotheholesinthewallassembly
andtighten.
•Placetwoofthebasesonaflatsurface,asshown.
• Fitthewallassemblyintoeachbaseandpushto“snap”inplace.
Hint: The wall is designed to fit the bases one way. If it does not
seem to fit, turn or switch one or both bases around and try again!
3
4

5
Assembly
•Locatetwooftherampslabeled1.
•Fittheendsoftherampsintotheslotsinthewall.
•Locatetheramplabeled3.
•Fittheendsoftherampintotheslotsinthewall.
•Fitthetoprampontothetopoftheassembly.
•Insertthreescrewsintothetoprampandtighten.
Top Ramp
Ramps
(Labeled1)
Ramp
(Labeled3)
Base
•Fitthebottomofthearchintotheremainingbase.Pushto
"snap"inplace.
Hint: The arch is designed to fit into the base one way. If it
does not seem to fit, turn the base around and try again.
5
7
6
8

6
Assembly
•Carefullyturntheassemblyaround.
•Fittheendsoftheremainingramplabeled1intotheslotsin
thewall.
•Locatetheramplabeled2.
•Fittheendsoftherampintotheremainingslotsinthewall.
•Whileholdingeachrampinplace,pushtherampsonboth
sidesofthewallto"snap"inplace.
• Firstfitthetabonthelongrampintotheslotinthebase A.
Pushto"snap"thelongrampinplace.
•Thenfitthetabontheotherendofthelongrampintothe
slotunderthetopramp B.Pushto"snap"inplace.
Long Ramp
Ramp
(Labeled2)
Ramp
(Labeled1)
A
B
9
10
11
12

7
1
6
2
7
3
8
4
9
5
10
Decoration
•Placethelabelsexactlyasshownintheillustrations.
•Forbestresults,avoidrepositioningalabelonceithas
beenapplied.
Assembly
Loop-the-Loop Ramp
13
•Fitthetabsontheendsoftheloop-the-looprampintothe
slotsinthebase.
•Pushto"snap"theloop-the-looprampinplace.

8
•Slidethepowerswitchonthebottomofthe
toyON .Whenyouarefinishedplaying
withthistoy,slidethepowerswitchOFF .
•Slidethevehiclesdowntherampsfor
doublerollercoasteraction!
•Pressthebuttontosendavehicledown
thesideramp!
•Watchthevehicledrivethroughthe
loop-the-loop.
•Liftthejumpattheendoftheloopto
sendthevehicleflying!
Power Switch
Fun Songs and Sounds!
Fit the flags into
any of the sockets
on the toy!