Fisher-Price H7172 User manual

www.fisher-price.com
Please keep this instruction
sheet for future reference,
as it contains important
information.
Requires three “AA”
batteries (included).
Adult assembly is required.
Tool required for assembly:
Phillips screwdriver
(not included).
Musical
Learning
Chair™
with activity table
H7172
Instructions

Before Use
Parts
Please keep small parts such as plastic tabs out of
children’s reach. Throw the plastic tab away.
Note: A plastic tab is attached to the toy for in-store
demonstration purposes.
While the tab may have already been removed, check the chair
bottom to be sure. If the plastic tab is still attached, pull and
remove the tab from the toy. Throw the plastic tab away.
CAUTION
4 Legs
Seat Bottom
Seat Back
Connector Cover
Table Base
Table Top
#4 x 1,5 cm (5/8") Screw – 10
Shown Actual Size
Note: Tighten or loosen all screws
with a Phillips screwdriver.
Do not over-tighten the screws.
Assembly
Seat Back
Seat Bottom
• Fit the chair back into the chair bottom, as shown.
1
• Position the chair assembly so the bottom is facing you.
• Insert two screws through the chair bottom and into the base.
Tighten the screws.
• Fit the four legs to the chair bottom, as shown.
Note: each leg fits in only one location.
• Insert a screw into each of the four legs. Tighten the screws.
This toy contains small parts
in its unassembled state.
Adult assembly is required.
CAUTION
1
2
3

Assembly
• Locate the connector coming from underside of the chair bottom.
• Insert the connector into the socket on the table base, as shown.
• Press down firmly to “snap” the table top onto the table base.
Note: This may require some force.
1
• Fit the connector cover onto the back of the table base,
as shown.
• Insert two screws into connector cover. Tighten the screws.
• Insert two screws through the table base into the leg. Tighten
the screws.
1
• Locate the connector coming from the table base.
• Insert and “snap” the connector into the socket on the underside
of the table top.
• Tuck the excess wire from the connector back down into the
opening in the table base.
Assembly is now complete.
Table Top
Connector
• Slide the table base onto the chair assembly, as shown.
Table Base Socket
Connector Cover
Connector
Back View
Back View
4
5
1
6
7
8
9

Battery Replacement Battery Safety Information
For best performance, we recommend replacing the
batteries that came with this toy with three, new alkaline
“AA”(LR6) batteries.
• Locate the battery compartment on the underside of the chair.
• Loosen the screw in the battery compartment door with a Phillips
screwdriver. Remove the battery compartment door.
• Insert three “AA” (LR6) alkaline batteries, as indicated inside the
battery compartment.
Hint: We recommend using alkaline batteries for longer life.
• Replace the battery compartment door and tighten the screw
with a Phillips screwdriver. Do not over-tighten.
• When lights or sounds from this toy become faint or stop,
it’s time for an adult to change the batteries!
Batteries may leak fluids that can cause a chemical burn injury or
ruin your toy. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types:
alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove
exhausted batteries from the toy. Dispose of batteries safely.
Do not dispose of batteries in a fire. The batteries may explode
or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type,
as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging.
• If removable, rechargeable batteries are used, they are only to
be charged under adult supervision.
1.5V x 3
“AA” (LR6)
Shown Actual Size
Battery Compartment Door
Care
• Wipe this toy with a clean cloth dampened with a mild soap
and water solution. Do not immerse this toy.
• This toy has no consumer serviceable parts. Do not take this
toy apart.
Bottom View

• Locate the mode switch on the top
of the toy.
• Slide the mode switch to either
learning mode or music
mode
ABC
or off o .
• When your child is finished playing
with this toy, slide the mode switch
to the off
o position.
• Locate the volume switch on the
underside of the chair.
• Adjust the volume to high or
low , for your child’s comfort.
Learning Mode Music Mode
Press down on the lamp
• Sit on the “magic” seat to hear the A-B-C song.
• Turn the book pages to learn about each animal and hear the
sound it makes.
• Turn the clock hands to hear a fun counting song.
• Press down on the lamp to light up coloured lights and learn
about on and off.
• Sit on the “magic” seat to hear a song. Stand up to stop the
song. Sit down to resume.
• Turn the book pages to hear a song and sound effect for
each animal.
• Turn the clock hands to hear Hickory Dickory Dock.
• Press down on the lamp to light up coloured lights and hear
a short ditty.
Mode Switch Volume Switch
Turn the pages in the book
Sit in the seat
Turn the clock hands
Two Interactive Play Modes!
ABC

Fisher-Price, Inc., a subsidiary of Mattel, Inc. East Aurora, New York 14052, U.S.A. H7172pr-0726
©2005 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. PRINTED IN CHINA
Make learning more fun with the whole collection of Laugh & Learn™ toys. With rich music, lyrics and lots of activities,
they combine early academics and everyday experiences, for the way kids really learn.
Each sold separately and subject to availability.
Consumer Information
Learn every day - through fun, familiar play!
H0671
H6075
G2809
G2811 G2810
G2808 H2219 C2807
Mattel UK Ltd, Vanwall Business Park, Maidenhead SL6 4UB. Helpline: 01628 500302.