Fisher-Price Y4228 User manual

Please keep this instruction sheet for future reference,
as it contains important information.
Requires three “AA” batteries (included).
Adult assembly is required for battery replacement.
Tool required for battery replacement: Phillips screwdriver (not included).
This toy is surface washable only. Do not immerse.
fisher-price.com
Y4228

Battery
Replacement
In exceptional circumstances, batteries
may leak fluids that can cause
a chemical burn injury or ruin your
product. To avoid battery leakage:
• Do not mix old and new batteries
or batteries of different types:
alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium).
• Insert batteries as indicated inside
the battery compartment.
• Remove batteries during long
periods of non-use. Always remove
exhausted batteries from the
product. Dispose of batteries safely.
Do not dispose of this product in
a fire. The batteries inside may
explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable
batteries.
• Remove rechargeable batteries from
the product before charging.
• If removable, rechargeable batteries
are used, they are only to be
charged under adult supervision.
1,5V x 3
"AA" (LR6)
• Protect the environment
by not disposing of this
product with household
waste (2002/96/EC).
Check your local
authority for recycling
advice and facilities.
For best results, we recommend replacing
the batteries that came with this toy with
three, new “AA” (LR6) alkaline batteries.
• Open the fasteners on the back of the
toy to access the battery compartment.
• Loosen the screw in the battery
compartment door with a Phillips
screwdriver and remove it. Throw
the exhausted batteries away.
• Insert three, new “AA” (LR6)
alkaline batteries.
• Replace the battery compartment
door and tighten the screw. Do not
over-tighten.
• Close the fasteners on the toy.
• If the toy begins to operate erratically
you may need to reset the electronics.
Slide the power/volume switch on the
back of the toy off and then back on.
• When lights and sounds become
faint or stop, it’s time for an adult to
change the batteries!
Battery Safety
Information

2 Interactive Play Modes!
• Open the fasteners on the back of the toy. Slide the power/volume to ON with
low volume or high volume to turn off try-me demonstration mode.
Use the power/volume switch to turn the toy OFF .
Press to turn on and start learning mode; press
Press to turn on and start learning mode; press
again for music mode; press once more to turn off.
again for music mode; press once more to turn off.
Press for fun
Press for fun
phrases and
phrases and
a special song!
a special song!
Learning Mode
• Press puppy’s left foot, right hand,
heart, tummy or left ear to learn
parts of the body. Press again to
learn a color.
• Press puppy’s left hand to hear fun
learning songs.
Music Mode
• Press puppy’s left foot, left ear, heart
or hands for hugs, kisses and other fun
phrases! Press again for more fun!
• Press puppy’s tummy hiccups,
laughing and more!
SLIDE SWITCH
SLIDE SWITCH
DOWN TO TURN OFF
DOWN TO TURN OFF
TRY-ME MODE
TRY-ME MODE

©2012 Mattel. All Rights Reserved.
PRINTED IN CHINA Y4228pr-0920
Consumer Information
FCC Statement (United States Only)
This equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio
or television reception, which can be
determined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced
radio/TV technician for help.
Note: Changes or modifications not
expressly approved by the manufacturer
responsible for compliance could void the
user’s authority to operate the equipment.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
CO
N
SU
MER
ASS
I
S
T
A
N
C
E
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa B.V., Gondel 1, 1186MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
ICES-003
This Class B digital apparatus complies
with Canadian ICES-003. Operation is
subject to the following two conditions:
(1) this device may not cause harmful
interference and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
NMB-003
Cet appareil numérique de la classe B
est conforme à la norme NMB-003 du
Canada. L’utilisation de ce dispositif
est autorisée seulement aux conditions
suivantes : (1) il ne doit pas produire
de brouillage et (2) l’utilisateur du
dispositif doit être prêt à accepter tout
brouillage radioélectrique reçu, même
si ce brouillage est susceptible de
compromettre le fonctionnement
du dispositif.