Flash Furniture LeatherSoft Upholstered Barstool with Black Metal... User manual

LeatherSoft Upholstered
Barstool with Black Metal Frame
AY-S01-BK-GG / AY-S01-BR-GG
Do not fully tighten screws until all pieces have been assembled.
Online Assembly Instructions: http://ftp.flashfurniture.com/AssemblyInstructions/AY-S01-BR-GG.pdf

STEP 2
STEP 1
PARTS
AMETAL TUBE
FRAME
SCREWS
FOOTREST
SEAT BACK
SEAT
CONNECTOR
B
C
D
E
F
G
H
I
J
Large Allen
Wrench
M6*16
4pcs
Small Allen
Wrench
SCREWS
SCREWS
M6*35
2pcs
M6*45
6pcs
STEP 4STEP 3
STEP 6STEP 5
J
A
B
I
F
H
G
H
I
I
I
D
C
E
STEP 1: Turn Metal
Tube Frames (Part A)
upside down and attach
footrest (Part B) to the
Metal Tube Frames then
tighten the pre-installed
screws inside the Footrest
using the Small Allen
Wrench (Part J)
STEP 2: Return chair to the
upright position and attach the
Connector (Part E) to the Metal
Tube Frame (Part A) using M6*16
Screws (Part F) and Large Allen
Wrench (Part I)
A
STEP 3: Lay the Seat (Part D)
upside down on a clean surface
and align the holes of the
Connector (Part E) with the pre-
drilled holes on the underside of
the seat. Attach the Connector
using (4) M6*45 Screws (Part H)
and Large Allen Wrench (Part I)
STEP 5B: Attach Seat Back (Part C)
to the upper part ot the Metal Tube Frame
(Part A) using M6*35 Screws (Part G)
and Large Allen Wrench (Part I)
STEP 5A:
Attach Seat Back (Part C) to
the lower part of the Metal
Tube Frame (Part A) using
M6*45 Screws/Bolts (Part H)
and Large Allen wrench
(Part I)
STEP 6: Return chair to
the upright position and
tighten all screws
STEP 4: Return chair to the
upright position