FLOS RF1035109 User manual

EN
WARNING! When installing and whenever acting on the appliance, ensure that the power supply has been switched off.
For the installation of the spare-part, it is necessary to consult a qualified electrician.
©2021 Flos -All rights reserved -www.flos.com
Flos reserves the right to introduce any changes to its own models, without prior notice.
REV. 1
DATE 24/08/2021
RF1035109
POWER CHARGER WITHELECTRICAL CABLE &PLUGS
Bon Jour
Unplugged
Bellhop
Battery
Last Order
Clear
Last Order
Fluted

1
WARNING! When installing and whenever acting on the appliance, ensure that the power supply has been switched off.
For the installation of the spare-part, it is necessary to consult a qualified electrician.
©2021 Flos -All rights reserved -www.flos.com
Flos reserves the right to introduce any changes to its own models, without prior notice.
EN
Fig.1
RECHARGING THE BATTERY. Insert the plug (G) in the power adaptor (H) in the preferred
working position (the plug can be inserted in any side of the power adaptor block) until you hear
the snap-in click (use the correct type of plug for the country the lamp is installed in); to remove the
plug press the power adaptor's push button (I). Insert the USB plug (L) of the cable provided in its
housing (M) on the power adaptor then insert the micro-USB plug (O) into the lamp's connector (P).
The complete recharging time is 3 hours. With the lamp turned on to 100% of the light intensity, the
operating autonomy without cable is 6 hours; after 6 hours the
light intensity automatically reduces by 20% and the lamp signals the need for recharge with three
flashes which will be repeated every 10 minutes until it is put on charge. NOTE: This product
includes a self-protection system. If it remains connected to the power source for more than the
indicated charging time, the service life of the battery will not be affected (1000 charging cycles
guaranteed).
RF1035109
POWER CHARGER WITH ELECTRICAL CABLE & PLUGS
REV. 1
DATE 24/08/2021
BON JOUR UNPLUGGED
F1037009
L
M
I
G
HO
P
UNLOCK
LOCK
CLICK!

2
WARNING! When installing and whenever acting on the appliance, ensure that the power supply has been switched off.
For the installation of the spare-part, it is necessary to consult a qualified electrician.
©2021 Flos -All rights reserved -www.flos.com
Flos reserves the right to introduce any changes to its own models, without prior notice.
EN
Fig.1
BATTERY RECHARGE.
Insert the plug (A) into the power adaptor (D) in the working position of your choice (the
plug can be inserted into any side of the power adaptor) until you hear the snap-in
fastener go click (use the correct type of plug for country the device is installed in); to
remove the plug, press the power adapter’s button (B). Insert the USB plug (C) of the
cable provided into the power adapter’s USB port (E).
D
C
B
BELLHOP BATTERY
F1060009
REV. 1
DATE 16/07/2021
A
UNLOC
K
LOCK
CLICK!
RF1035109
POWER CHARGER WHIT ELECTRICAL CABLE & PLUGS

3
WARNING! When installing and whenever acting on the appliance, ensure that the power supply has been switched off.
For the installation of the spare-part, it is necessary to consult a qualified electrician.
©2021 Flos -All rights reserved -www.flos.com
Flos reserves the right to introduce any changes to its own models, without prior notice.
EN
Fig.2
BATTERY RECHARGE
. Insert the micro-USB plug (F) into the device’s connector (G); the
recharge status is indicated by the pulse frequency of the led (L) positioned on the base
of the device: when the charge level is less than 20% the led flashes at a high frequency
(every 0.5 seconds), from 20% to 90% the led flashes at a lower frequency (every 1
second), at full charge the led stays on continuously. The complete charging time is 3
hours. With the device on at 100% light intensity, the wireless operating autonomy is 6
hours (By reducing the light’s intensity it is possible to maximise the lifespan up to 24
hours ); after 6 hours, the light intensity automatically lowers to 20% and the device
signals the need to recharge with a high frequency flashing of the led (L) (every 0.2
seconds) until it is put on charge or until the battery runs down completely. NB: the
product is equipped with a self-protection system: if it stays connected to the power
adaptor beyond the indicated charging time it won’t affect the battery life (500 recharges
guaranteed).
G
L
F
BELLHOP BATTERY
F1060009
REV. 1
DATE 16/07/2021
RF1035109
POWER CHARGER WHIT ELECTRICAL CABLE & PLUGS

4
WARNING! When installing and whenever acting on the appliance, ensure that the power supply has been switched off.
For the installation of the spare-part, it is necessary to consult a qualified electrician.
©2021 Flos -All rights reserved -www.flos.com
Flos reserves the right to introduce any changes to its own models, without prior notice.
EN
Fig.1
RF1035109
POWER CHARGER WITH ELECTRICAL CABLE & PLUGS
LAST ORDER CLEAR F3693015
REV. 0
DATE 20/09/2021
RECHARGING THE BATTERY. Insert the plug (G) in the power adaptor (H) in the preferred
working position (the plug can be inserted in any side of the power adaptor block) until you hear
the snap-in click (use the correct type of plug for the country the lamp is installed in); to remove the
plug press the power adaptor's push button (I). Insert the USB plug (L) of the cable provided in its
housing (M) on the power adaptor then insert the micro-USB plug (O) into the lamp's connector (P).
D
C
B
A
UNLOCK
CLICK!

5
WARNING! When installing and whenever acting on the appliance, ensure that the power supply has been switched off.
For the installation of the spare-part, it is necessary to consult a qualified electrician.
©2021 Flos -All rights reserved -www.flos.com
Flos reserves the right to introduce any changes to its own models, without prior notice.
EN
Fig.1
RECHARGING THE BATTERY. Insert the plug (G) in the power adaptor (H) in the preferred
working position (the plug can be inserted in any side of the power adaptor block) until you hear
the snap-in click (use the correct type of plug for the country the lamp is installed in); to remove the
plug press the power adaptor's push button (I). Insert the USB plug (L) of the cable provided in its
housing (M) on the power adaptor then insert the micro-USB plug (O) into the lamp's connector (P).
RF1035109
POWER CHARGER WITH ELECTRICAL CABLE & PLUGS
REV. 0
DATE 20/09/2021
LAST ORDER FLUTED F3694015
D
C
B
A
UNLOCK
CLICK!