BROSA Capra Tripod Floor Lamp User manual

Capra Tripod
Floor Lamp
A S S E M B LY GU I D E
V2

FOR YOUR SAFETY
Lift, don’t drag. This protects
your floor and product.
Avoid loose screws. Tighten
fixtures every few months.
Assembly requires 2 people.
It's always easier with a
friend.
Contact our support online
or call 1300 027 672.
Check the assembly guide
for required components.
?
Assembling this product on
a soft surface protects its
finish.

Safety
1. For indoor use only.
2. Follow instructions carefully. Any deviations may be hazardous, or
void your warranty.
3. If the external flexible cable is damaged, it should be replaced
immediately by a certified electrician.
4. Never use a bulb of a greater wattage than recommended.
5. To replace the bulb, unplug the lamp from its power source and
allow it to cool first. Then change the bulb, plug it in and switch it on.
6. This product is not suitable for children under 14 years of age.
7. Periodically check and re-tighten all screws and fasteners.
8. Switch off and wipe down your lamp with a clean cloth as needed.
9. Firmly secure all pieces. Small parts may present a choking hazard.
Notes:
1. Bulb is not included.
MAX.60W E27
220-240V ~ 50Hz

Components
Hardware
Before you get started, check you have all of the pieces below.
If anything’s missing, we’ll sort it out right away. Simply visit:
www.brosa.com.au/pages/product-return-and-parts-request
A x 1
①Lamp Holder x 1 ②Leg x 3
③Shade x 1

Step 1 Unscrew the bolts attached to the top of the leg ②
and remove them using the Allen key A. Keep them
for the following assembly.
Repeat this for the remaining legs.
A x 1
A
②

Step 2 Align one leg with the holes on the round plate of the
lamp holder ①. Make sure the holes on each
component overlap. Insert the bolts removed in Step
1 into the holes and tighten them with the Allen key A.
A x 1
①A

Step 3 Repeat Step 2 for the remaining legs.
A x 1
A

Step 4 Unscrew the shade ring and remove it from the bulb
holder.

Step 5 Attach the shade ③ to the bulb holder.
Attach the shade ring to the bulb holder again and
screw it until the shade is tight and secure.
③

Step 6 Gently screw the correct bulb (not included) into
the bulb holder.
Enjoy! We hope your new Capra Tripod Floor Lamp
lights up your life!