
3
• Use only replacement parts that are approved by Fluke Networks.
• Do not touch voltages > 30 V AC rms, 42 V AC peak, or 60 V DC.
• Do not use the Product around explosive gas, vapor, or in damp or
wet environments.
• Charge the battery indoors.
• Use the Product only as specied, or the protection supplied by
the Product can be compromised.
• Do not use and disable the Product if it is damaged.
• Do not use the Product if it operates incorrectly.
• Batteries contain hazardous chemicals that can cause burns or
explode. If exposure to chemicals occurs, clean with water and get
medical aid.
• Remove the batteries if the Product is not used for an extended
period of time, or if stored in temperatures above 50 °C. If the
batteries are not removed, battery leakage can damage the
Product.
• Replace the rechargeable battery after 5 years of moderate use
or 2 years of heavy use. Moderate use is dened as recharged
twice a week. Heavy use is dened as discharged to cutoff and
recharged daily.
• Disconnect the battery charger and move the Product or battery
to a cool, non-ammable location if the rechargeable battery
becomes hot (>50 °C, >122 °F) during the charge period.
• The battery door must be closed and locked before you operate
the Product.
• Repair the Product before use if the battery leaks.
• Recharge the batteries when the low battery indicator shows to
prevent incorrect measurements.
• Do not disassemble or crush battery cells and battery packs.
• Do not put battery cells and battery packs near heat or re. Do
not put in sunlight.
• Have an approved technician repair the Product.
• For Products with rechargeable batteries, use only AC adapters
approved by Fluke Networks for use with the Product to supply
power to the Product and charge the battery.
WWarning: Class 1 and Class 2 Laser Products*
To prevent eye damage and personal injury:
• Do not look directly into optical connectors. Some optical
equipment emits invisible radiation that can cause permanent
damage to your eyes.