Forging Mount HY4107 User manual

®
Instruction Manual
Wooden Base Universal TV Stand
MAX
MAX
55
99LBS HY4107
Thank you for choosing our product! We strive to provide the best quality
and services for our customers. Would you kindly share your experience
on Amazon if you are satisfied? If you have any questions, please feel
free contact us.
Email：[email protected]
We’re ready to help!

Safety Caution
-1-
Wooden Base
Support Pillar
TV P late
TV B rackets
X 1X 4
X 2 X 2 X 4 X 4 X 4
X 4 X 4 X 8 X 8 X 4
X 4 X 4 X 4 X 4
Safety Lock Wire C lip Bolt
M6 x 40 Bolt
M6 x 25 Nut
M6
Washer Allen Key
X 1
01
X 1
02
X 1 03
X 2 04
•Carefully open the carton, remove contents and lay out on cardbard or other protective
surface to avoid damage.
•Check to assure that all components were received undamaged. Do not use damaged or
defective parts.lf you require replacement parts, contact customer service at
[email protected]
•Carefully read all instructions before attempting installation.
UNPACKING INSTRUCTIONS
IMPORTANT SAFETY INFORMATION
•Install and operate this product with care. Please read this instruction before beginning the
installation, and carefully follow all instructions contained herein. Use proper tools during
installation.
•
If you do not understand the instructions or have any concerns or questions, please contact
customer service at
[email protected]
WARNING: Exceeding the weight capacity can result in serious personal injury or damage to equipment!
over resulting in death or serious injury!
This product contains small items that could be a choking hazard if swallowed.
Keep these items away from yong children
:
It is the installer’s responsibility to make sure the combined weight of HY4107 and the display
does not exceed 99 ibs(45kg).Use with heavier televisions may result in instability causing tip
Supplied parts
12
Spacers
Foot pad
X 5
W
X
S Y LT
QR

-2-
STEP 1 Assemble the TV Stand
STEP 1-2
Height
Adjustable
1
2
3
02
R
L
01
R
Y
R
Q
T
03
Place foot pads (Q)on the bottom of the wooden base at the corners
W
STEP 1-3 Attach the TV Plate to Support Pillar
Attach the Support Pillar to the Wooden Base

3
Please select the proper screw length for your
TV by hand tightening to check your flat panel
thread depth.
When attaching brackets to the flat screen,
Too Short Too Long
Correct Correct
First, make sure the diameter of the bolt(A-F) fi ts your TV. Then, please see the diagram above.
You will need to thread the bolt into the TV using the correct washer (G) and spacer (Hor I) if
necessary with a screwdriver(Not included). Please make sure the monitor brackets(04) are
vertically centered and level with each other.
G
Step 2 Mounting the TV Brackets(04) to your TV
be careful not to over tighten screws
and be sure that screws do not bottom
out in the mounting holes
2.1
H I B D F
A C E
04
2.2
G

Insert the Safety Lock
in the bottom of the bracket
and then tighten the screws.
The
first
choice The
second
choice
Attaching S
-3-
S
X
STEP 3 Hang TV to the TV Plate
STEP 2-3 cable management (Attaching wire clips)
If you find your TV set is too close to the base, please take off the TV from the stand.
Then, change to the second choice to allow more space between TV and
the wooden base (01).
STEP 4 Height Adjustable of the TV Brackets