Fortin EVO-ONE FTX75 User manual

Fortin FTX44, FTX64, FTX75 with EVO
***WARNING FTX5, FTX25 and ATX5 are not compatible with the EV
*** nly compatible with FMH 2
1. Plug in the Flash-Link-
2 updater into the comp
provided USB cable.
2. Run Flash Link Manager
Software.
Fortin FTX44, FTX64, FTX75 with EVO
-
ALL
***WARNING FTX5, FTX25 and ATX5 are not compatible with the EV
-
ALL
*** nly compatible with FMH 2
-way Antennas
2 updater into the comp
uter’s USB port with the
Software.
ALL
ALL
uter’s USB port with the

3. Plug in the Module you want to Flash update with the provided DATALINK
cable.
4. Click on EV -ALL PTI NS tab.
5. Activate Supported RF Kits and option H2 – Fortin 2.

6. Click SAVE PTI NS.
7. Wait for the ptions Saved message to appear in the top right corner.
8. Connect the FMH antenna and the EV -ALL together with the cable adapter
|# PART N . : “RF-A2A”.
StandAlone without T-Harness.

StandAlone with T-Harness
Or use the “Do-It-Yourself” way :
Modify the Antenna cable supplied with the Fortin Antenna with a knife as
shown. Attach a chassis Ground on Pin 3 and a 12V constant on Pin 4 of the
supplied Antenna cable as shown.

9. To program remotes on the units, Press and hold the F RTIN programming button.
Insert the 4-Pin (Data-Link) connector. Release the programming button when the LEDs
are BLUE AND RED.
Press and hold the F RTIN programming button again for 5 seconds (Blue and Red will
go ff and back n after 5 seconds). Turn ignition n, the Yellow LED will turn n.
The BLUE and RED LED’s will flash once to confirm device is coded.
10. Turn the vehicle Ignition ff and test the installation.