Frontgate LYNNE 165033 User manual

LYNNE BED

LYNNE BED
PARTS INCLUDED
A
[1]
Headboard
B
[2]
Side Rail
C
[1]
Footboard
D
[5]
Cross Support Slat
NO.
DESCRIPTION
Qty
1
Threaded Rods
9 pieces
2
Curved Washers
9 pieces
3
Look Washers
9 pieces
4
Nuts
9pieces
5
Spanner Wrench
1 pieces
6
Screws
12 pieces
The Hardware is packed with the Headboard (A)
TOOLS NEEDED:
Phillips Screwdriver (not included)
ASSEMBLY INSTRUCTIONS
Note:
Bed must be assembled by at least two people.
Please read instructions carefully before assembling bed.
Use the above parts and hardware list to identify each each component.
Keep all packing materials until assembly is complete to avoid loss of smaller parts.
STEP 1
1, Place the Headboard (A) flat on the floor covered with with a protective material to prevent
damage.
2, Stand the Headboard (A) upright and hook Side Rails (B) into Headboard (A) as shown in the
Diagram I. Tighten the Allen Bolts(2),with Allen Key(3)
3, Repeat the procedure with the Footboard (C).

LYNNE BED
STEP 2
1, Place the Cross Support Slat (D) on the inside of the side rails (B).
Screw the ends of the slats to the cleats using Screw (1), as shown in
Diagram II.
Thank you for your purchase