FSR SYM-IN Service manual

FSR 244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: [phone] - Fax: [phone]
43346 LIT1728
TYPE FLANGE SIZE
A FRAME
B FRAME
C FRAME
D FRAME
6.30"
7.73"
8.69"
10.12"
CUT OUT SIZE
6-1/16"
7-7/16"
8-7/16"
9-7/8"
SYM-IN Installation Instructions
1. SELECT LOCATION FOR ASSEMBLY AND CUT APPLICABLE HOLE
IN TABLE. INSERT ASSEMBLY INTO HOLE AND PUSH DOWN ON
FLANGES. TO REMOVE ASSEMBLY FROM TABLE, PRY BOTTOM
OF CAPTURE SPRING OFF ASSEMBLY FRAME.
ASSEMBLY
HOLE CUT OUT
TABLE
CAPTURE SPRING
TO REMOVE ASSEMBLY, INSERT
SCREWDRIVER THRU OPENING AND
PRY BOTTOM OF CAPTURE SPRING
OUT OF ASSEMBLY FRAME LIP, BOTH
SIDES. LIFT ASSEMBLY OUT OF HOLE
TO COMPLETE REMOVAL.
SHARP TO 3/16" MAX
RADIUS CORNERS
5.00"
CUT OUT
SIZE
FLANGE
SIZE

2.
INSERT INSTALLATION AND REMOVAL
a. TO INSTALL, PUSH INSERT WHERE INDICATED,
SNAPPING INSERT INTO ASSEMBLY. b. TO REMOVE, INSERT SCREWDRIVER WHERE INDICATED, PRYING INSERT OUT OF ASSEMBLY.
PUSH HERE
PUSH HERE
INSERT SCREWDRIVER HERE
INSERT SCREWDRIVER HERE
IF APPLICABLE, INSTALL KEYSTONE CONNECTORS (SOLD SEPARATELY) INTO
INSERTS (SINGLE OR DUAL), MAKE WIRING CONNECTIONS AS REQUIRED, AND
INSTALL INSERTS INTO ASSEMBLY. IF KEYSTONE CONNECTORS ARE TO BE
INSTALLED AT A LATER DATE INSTALL BLANK INSERTS. FRONT FACE MUST BE
CLOSED WITH KEYSTONE OR BLANK INSERTS.