|
3. Press the [Menu] button.
The [Settings Menu] screen is shown on the LCD.
4. Select [3: Test Print] by pressing the [] button
or the [] button, and confirm the selection by
pressing the [Scan/Enter] button.
The [No. of Sheets Scanned] screen is shown on
the LCD.
ATTENTION
If the Imprinter is disconnected or not connected properly,
[Cannot use this function because the Imprinter is not
connected.] is shown on the LCD.
5. Select [1: Single Sheet Only] or [2: Multiple
Sheets] by pressing the [] button or the []
button, and then confirm the selection by
pressing the [Scan/Enter] button.
When [2: Multiple Sheets] is selected, printing is performed
for all sheets set in the scanner.
The [Print Pattern] screen is shown on the LCD.
6. Select a print pattern by pressing the [] button
or the [] button, and then confirm the selection
by pressing the [Scan/Enter] button.
HINT
Below are the print test patterns:
Test Pattern 1 (Horizontal):
ABCDEFGHIJKLMNOPQRSTUVWXYZ[¥]^_`00000000
Test Pattern 2 (Horizontal):
abcdefghijklmnopqrstuvwxyz{|}‾00000000
Test Pattern 3 (Horizontal):
!"#$%&'()*+,-./0123456789:;<=>?@00000000
Test Pattern 4 (Vertical):
ABCDEFGHIJKLMNOPQRSTUVWXYZ[¥]^_`00000000
Test Pattern 5 (Vertical):
abcdefghijklmnopqrstuvwxyz{|}‾00000000
Test Pattern 6 (Vertical):
!"#$%&'()*+,-./0123456789:;<=>?@00000000
The numbering section "00000000" increases in increments
of one, starting from 0 (zero).
The [Test Print] screen is shown on the LCD.
7. Select [1: Yes] by pressing the [] button or the
[] button, and then confirm the selection by
pressing the [Scan/Enter] button.
The blank sheet is fed into the scanner, and the
imprinter will print out a print test pattern leaving
a 5 mm gap (with an allowance of 4 mm inwards
or outwards) from the edge of the document.
8. To finish the print test, press the [Power] button
on the operator panel of the scanner to turn off
the power of the scanner.
Menu
Scan/Enter
Check
Power
Stop/Clear
Test Pattern Print Sample
