Func COOEE WALL TILES User manual

PAGE 1
ASSEMBLY GUIDE
SIZE GUIDE & CONTENTS FOR Wall Tiles
x1 Rectangular
Wall Tile
Tools you will need:
1207mm x 603mm
[47.5in x 23.75in]
Phillips Head
Screw Driver
Spirit LevelLaser Level Tape Measure Electric Drill
One Person
Install
CAUTION
• Clear open space for install
• Installer is responsible for installing MDF Battens
clips to the wall.
• + 6.5lbs lift required
COOEE
WALL TILES
0
603mm x 603mm
[23.75in x 23.75in]
x2 MDF Batten
800mm [31.50in]
x2 MDF Batten
400mm [15.75in]
Suitable Screws For Different
Surfaces
Screws Are Not Included
603mm x 603mm
[23.75in x 23.75in]
x2 MDF Batten
400mm [15.75in]
x1 Square
Wall Tile
x1 Circular
Wall Tile
1
Prepare your MDF Battens before measurement.
Drill holes on MDF Battens suitable for you select-
ed screws (Screws For Different Surfaces).
Two holes per MDF Batten required.
Before drillinling check the surface for obstacles.

PAGE 2
ASSEMBLY GUIDE
a.
Insert MDF Battens into Wall Tile. Measure
from the floor to the desired height of the
bottom MDF Batten. See drawing above.
b.
Match Wall Tile spacing onto your solid wall
(Surface). Ensure MDF Battens are the correct
direction and level. Check with a laser or
spirit level.
Installer to use fixings appropriate to Solid
wall construction.
COOEE
WALL TILES
2
HEIGHT OF THE GROUND
SURFACE
MDF
BATTEN
2.35in 59.8mm
18.38in 466.8mm
Installer is responsible for
installing MDF BATTENS to the wall.
Ensuring they are structurally
sound to hang a Collaboration
Wallboard / Whiteboard and desired
accessories.
3
a.
Ensure MDF Battens are correct direction
for installation. Also make sure the
screws are flush as they will interfere
with acoustic PET panel.
Gravity
CAUTION
SURFACE
MDF
BATTEN
WALL TILE

PAGE 3
ASSEMBLY GUIDE
a.
When installing multiple Cooee Wall Tiles, laser level is recommend as the floor or ceiling may
not be level. This will warrant any mis-alignment and help in a fast and accurate install.
COOEE
WALL TILES
4
GROUND LINE
x1 Assembled
Wall Tile
a.
Once MDF Battens are secure on the solid wall,
the Cooee Wall Tile can be lifted in place.
Make sure pressure is applied at the front of
the acoustic PET to ensure MDF Battens and Wall
Tile lock into each other.
b.
Once Cooee Wall Tile is lifted in place.
Make sure it is centered over the MDF
Battens. Slight adjusments on both sides is
possible.
5