Furniture of America Claremont CM1925BR User manual

Rev: 15-03-06

Back Panel

Insert headboard legs (#2)
into the back panel (#1).
I. Align the left and right side panels (#3) to the back panel (#1).
II. Insert bolts (#B) and secure using the Allen wrench (#F).

I. Align the cross bar (#4) to the left and right side panels (#3)
II. Insert washer (#E) onto the bolt (#A) and secure using the
Allen wrench (#G).
I. Insert the base frames (#3) onto the side bars.
II. Insert flat washer (#D) onto the bolt (#C) and secure using the
Allen wrench (#F).
ASSEMBLY IS COMPLETED

Rev: 15-03-06

I. Align the 3 casters (#4) to the pre-drilled holes on the trundle frame (#1).
II. Insert bolt (#C) to the outer corners followed by the flat washer (#F)
then the hex nut (#E) on the other side, in that order. Secure by firmly
holding the hex nut (#E) with the wrench (#H) and using the Allen
wrench on the bolt. Note: Use bolt (#B) on the center caster.
I. Align the support legs (#3) to the remaining corners of the trundle
frame (#1).
II. Insert bolt (#D) and secure using the Allen wrench (#G).

I. Insert trundle handles (#2) into the pre-drilled holes on the trundle frame (#1).
II. Insert bolt (#A) and secure using the Allen wrench (#G).
I. Insert trundle side handles (#5) into the pre-drilled holes
on the trundle frame (#1).
II. Insert bolt (#A) and secure using the Allen wrench (#G).
ASSEMBLY IS COMPLETED