Furniture of America CM-AC6278-S-3A User manual

Align top panel (#1).
Align first shelf (#3).
Align second shelf (#4).
Align third shelf (#3)
Align bottom shelf (#5)
1. Place the right side frame
(#2) onto a protected surface.
2. After aligning each
panel and shelves,
insert 2 bolts (#A)
into the holes along
the sides of each.
Secure using the
Allen wrench (#D).
1. Place the left side frame
(#6) onto the other ends
of the panels/shelves.
2. Insert 2 bolts (#A) into
the holes along the
inner sides of the panels
/shelves. Secure using
the Allen wrench (#D).

1. Align the top of one cross bar (#7)
to the back side of the side frames.
2. Insert a bolt (#B) and secure using
the Allen wrench (#D). Note, do
not tighten completely.
3. Align the bottom end of the cross
bar (#7) to the hole along the
bottom side of the side frames.
4. Insert a bolt (#B) and secure using
the Allen wrench (#D). Now tighten
completely. Repeat process for
the second cross bar (#7).
5. After creating the X with the
cross bars (#7), insert a bolt
(#B) into the center of the X.
Secure using the Allen wrench.
Select a location where you want the shelf
mounted. Mark on the wall the location
where the wall anchor (#K5) will be placed.
Drill a hole for the anchor slightly smaller
than the size of the screw. Push the anchor
(#K5) as far as it will go with your finger.
Tap gently with a hammer until the anchor
is in. Then align the bracket (#K1) to the
anchor and insert a long screw (#K3). Align
the other bracket (#K1) to the shelf and
insert a short screw (#K4). Secure using a
Phillips screwdriver. Lastly, insert the tie
wrap into both brackets and tighten.
ASSEMBLY IS COMPLETED