Furniture of America CM4265-S User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
CM4265-S
Assembly Instructions
Tools Required for Assembly:
Rev.14-08-22
Page 1 of 4
DIFFICULT
ASSEMBLY RATING
Allen Wrench (Included)
2 PERSONS RECOMMENDED

Page 2 of 4

#3 x 4 pcs
Leg
Parts List
#1 x 1 pc
Table Top
#2 x 1 pc
Shelf
#A x 12 pcs
Bolt 5/16”x2”
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
MD
Page 3 of 4
#C x 12 pcs
Lock Washer
#B x 12 pcs
Flat Washer
#D x 1 pc
Allen Wrench
Due to the size and/or weight of this product, it is highly
recommended that the assembly should be done near the
area of its intended location. Make sure you have enough
space to move around during the assembly.ALWAYS have
at least two people to help with transporting and assembling
the product to avoid any potential injury and/or damage.

Page 4 of 4
I. Align the shelf (#2) with the pre-
drilled holes of the 4 legs (#3).
II. Prepare 4 bolt assemblies by
inserting FIRST the lock washer
(#C) onto the bolt (#A) and then
the flat washer (#B) onto the
SAME bolt (#A), in that order.
III. Insert the bolt assemblies
through the pre-drilled holes on
the corners of the shelf (#2) and
secure those bolts using the
Allen wrench (#D) to lock them
with the legs (#3).
IV. Carefully turn the completed
table upright. Make sure the
table is rested on a flat surface
and does not feel loose or
wobbly. If it does, double check
that the bolts/screws are secured
and properly tightened.
#A x 8 pcs
#B x 8 pcs
#C x 8 pcs
Turn right (clockwise) to tighten
Turn right (clockwise) to tighten
I. Carefully place the table top (#1)
facing down on a protective
surface.
II. Align the legs (#3) with the pre-
drilled holes on the bottom
corners of the table top (#1).
III. Prepare 8 bolt assemblies by
inserting FIRST the lock washer
(#C) onto the bolt (#A) and then
the flat washer (#B) onto the
SAME bolt (#A), in that order.
IV. Insert the bolt assemblies
through the pre-drilled holes on
the bottom corners of the table
top (#1) and secure those bolts
using the Allen wrench (#D) to
lock them with the legs (#3).
#A x 4 pcs
#B x 4 pcs
#C x 4 pcs
ASSEMBLY IS COMPLETED
#3