Furniture of America Syracuse CM7129D User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
CM7129D
Assembly Instructions
Tools Required for Assembly:
Rev.14-11-28
Page 1 of 5
DIFFICULT
ASSEMBLY RATING
2 PERSONS RECOMMENDED
Allen Wrench (Included)
CM7129M
DRESSER AND MIRRORARE SOLD AND PACKED SEPARATELY

Page 2 of 5

Parts List
#1 x 1 pc
Dresser
#2 x 4 pcs
Foot
#3 x 1 pc
Support Leg
#A x 8 pcs
Bolt 1/4”x1-3/8”
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
MD
Page 3 of 5
Hardware List
#D x 1 pc
Allen Wrench
#C x 8 pcs
Flat Washer
#B x 8 pcs
Lock Washer
#4 x 1 pc
Mirror
#5 x 2 pcs
Support Rail
Due to the size and/or weight of this product, it is
highly recommended that the assembly should be
done near the area of its intended location. Make
sure you have enough space to move around during
the assembly.ALWAYS have at least two people to
help with transporting and assembling the product to
avoid any potential injury and/or damage, especially
with the fragile nature of the mirror.

Page 4 of 5
Turn right (clockwise) to tighten
With the help of another person, carefully place the dresser
(#1) on its back over a protected surface. Align the threaded
end of the 4 feet (#2) with the pre-drilled holes on the bottom
of the dresser (#1) and tighten by hand until secured.
Align the threaded end of the support leg (#3) with the pre-drilled hole
on the bottom of the dresser (#1) and tighten by hand until secured.
Turn right (clockwise) to tighten

Page 5 of 5
Turn right (clockwise) to tighten
I. The 2 support rails (#5) are already attached behind the dresser
(#1). Position the support rails (#5) vertically to align with the pre-
drilled holes of the dresser (#1) and the mirror (#4).
II. Prepare 6 bolt assemblies by inserting FIRST the lock washer
(#B) onto the bolt (#A) and then the flat washer (#C) onto the
SAME bolt (#A), in that order. The other 2 bolt assemblies are
already attached to the support rails (#4) from the factory.
III. Insert the bolt assemblies through the support rails (#5) and
secure those bolts using an Allen wrench (#D) to lock with the
dresser (#1) and the mirror (#4). Tighten all bolts, including those
that were already attached from the factory.
IV. If needed, adjust the leveler according to the ground level. To
lower or to raise the support leg, turn the leveler clockwise or
counterclockwise, respectively.
#A x 8 pcs
#B x 8 pcs
#C x 8 pcs
ASSEMBLY IS COMPLETED