Furniture of America CM7351Q User manual

Insert the rail's (#3) latch into
the little gap on the headboard
(#1) and footboard (#2) until
it's sturdy and locked. Make
sure the rails (#3) are facing
and positioned correctly as
seen on the picture.
Attach support leg (#5) to each slat (#4) by twisting
the leg until it's tight. Adjust the leg according to
ground level.

Place the slats (#4) horizontally as
shown on the picture. Make sure
the holes from the slat (#4) align
with the side rails (#3). Use
screwdriver to screw in the screws
(#A) tight.

Insert the rail's (#3) latch into
the little gap on the headboard
(#1) and footboard (#2) until
it's sturdy and locked. Make
sure the rails (#3) are facing
and positioned correctly as
seen on the picture.
Attach support leg (#5) to each slat (#4) by twisting the
leg until it's tight. Adjust the leg according to ground
level.

Place the slats (#4) horizontally as
shown on the picture. Make sure the
holes from the slat (#4) align with
the side rails (#3). Use screwdriver
to screw in the screws (#A) tight.

Insert the rail's (#3) latch into the little gap on the
headboard (#1) and footboard (#2) until it's sturdy and
locked. Make sure the rails (#3) are facing and
positioned correctly as seen on the picture.
Attach two support legs (#5) to each slat (#4) by twisting the leg until it's tight. Adjust the leg
according to ground level.

Place the slats (#4) horizontally as
shown on the picture. Make sure the
holes from the slat (#4) align with
the side rails (#3). Use screwdriver
to screw in the screws (#A) tight.

Insert the rail's (#3) latch into
the little gap on the headboard
(#1) and footboard (#2) until
it's sturdy and locked. Make
sure the rails (#3) are facing
and positioned correctly as
seen on the picture.
Attach two support legs (#5) to each slat (#4) by twisting the leg
until it's tight. Adjust the leg according to ground level.

Place the slats (#4) horizontally as shown
on the picture. Make sure the holes from
the slat (#4) align with the side rails (#3).
Use screwdriver to screw in the screws
(#A) tight.