Furniture of America Palomino CM7777M User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
CM7777D
Assembly Instructions
Tools Required for Assembly:
Rev.14-06-16
Page 1 of 4
DIFFICULT
ASSEMBLY RATING
2 PERSONS RECOMMENDED
Allen Wrench (Included)
CM7777M
DRESSER AND MIRRORARE SOLD AND PACKED SEPARATELY

Page 2 of 4

Parts List
#1 x 1 pc
Mirror
#2 x 2 pcs
Mirror Support Rail
#3 x 1 pc
Dresser
#A x 6 pcs
Bolt 1/4”x1-3/8”
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
Due to the size and/or weight of this product, it is
highly recommended that the assembly should be
done near the area of its intended location. Make
sure you have enough space to move around during
the assembly. ALWAYS have at least two people to
help with transporting and assembling the product to
avoid any potential injury and/or damage, especially
with the fragile nature of the mirror.
MD
Page 3 of 4
Hardware List
#D x 1 pc
Allen Wrench
#C x 6 pcs
Lock Washer
#B x 6 pcs
Flat Washer
Please note that 2 pcs each of hardware #A, #B and #C
are already attached with the mirror support rails behind
the dresser.

Backside
Page 4 of 4
Turn right (clockwise) to tighten
Adjust the leveler according to
the ground level. To lower or
to raise the center leg, you
need to turn the leveler
clockwise or counterclockwise,
respectively.
I. The two mirror support rails (#2) are already attached behind the dresser (#3).
Position the mirror support rails (#2) vertically to align with the pre-drilled holes of
the dresser (#3)AND the mirror (#1).
II. Prepare 6 bolt assemblies by inserting FIRST the lock washer (#C) onto the bolt
(#A) and then the flat washer (#B) onto the SAME bolt (#A), in that order. The
other 2 bolt assemblies are already attached to the mirror support rails (#2) from
the factory.
III. Insert the bolt assemblies onto the mirror support rails (#2) and secure those
bolts using an Allen wrench (#D) to lock with the dresser (#3) AND the mirror (#1).
IV. Tighten all bolts, including those that were already attached from the factory.
Backside #A x 8 pcs
#B x 8 pcs
#C x 8 pcs
ASSEMBLY IS COMPLETED